Dimensions Of Curt And Hidden Hitch Long Ball Mounts

Question:

I am looking at D-26 and 80232. On D-26 what is the overall length and what is the length from the front of the hitch pin hole to the back of the curved piece that is welded to the square tubing. Perpendicular to the square tubing please. I need a longer than normal one to clear her bumper. However I dont want it to be any longer than necessary. Her bumper is right on top of the receiver. Can you also tell me those measurements for 80232. I already have overall length of that one. Thank you.

Helpful Expert Reply:

I went to our warehouse and took some measurements of part # D-26 and part # 80232 for you.

The overall length of part # D-26 is 16-1/2 inches. The distance from the center of the hitch pin hole to the back of the ball mount plate is 8-1/4 inches and to the horizontal plane of the ball mount plate it is 10-1/2 inches.

The overall length of part # 80232 is 20 inches. The distance form the center of the hitch pin hole to the back of the ball mount plate is 11-1/2 inches and to the horizontal plane of the ball mount plate it is 13-3/4 inches.

I have attached photos of each of these ball mounts with the dimensions shown you can check out.

Both of these ball mounts use a hitch ball with a 1-inch shank. For a 2-inch diameter ball I recommend part # 63845. for a 1-7/8 inch ball I recommend part # 19261.

Click to Enlarge
Click to Enlarge
helpful expert reply by:
Jeffrey L

Ask The Experts a Question >>


Products Referenced in This Question




Product Page this Question was Asked From