Is There a Weld Stop On the Curt Hitch part # C11405
Updated 01/07/2016 | Published 01/06/2016
Products Featured in This Question
Question:
Does this hitch have an internal back stop in the receiver tube? If so what is the measurement from the pin hole to the back stop. This is important to know when selection a bike rack to insure fit.
asked by: Brad
Expert Reply:
The hitch tube of the Curt hitch part # C11405 that you referenced is totally open all the way through.
You may also be referring to the weld stop that some Class I hitches install in the tube to prevent the use of Class II accessories in them. Curt hitches do not have that.
Curt requires the use of their stabilizer strap part # 18050 when using their hitch to carry a non-supported load like a bike rack. I attached a review video for you to check for the strap as well.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Bike Rack for E-Bikes on 2020 Acura RDX With 1-1/4" Receiver
- Q&A: Least Visible Trailer Hitch Recommendation for 2020 Ford Mustang Fastback
- Q&A: Trailer Hitch Recommendation for 2015 Mustang Fastback
- Q&A: Hitch Receiver for a 2021 and 2022 Ford Mustang Mach-E GT Preformance Edition
- Q&A: Will the Curt Hitch item # C11405 Fit a 2023 Ford Mustang Fastback?
- Q&A: How To Haul An Electric Bike With A 2019 Ford Mustang Convertible
- Q&A: 2018 Mustang GT Trailer Hitch Recommendation
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Trailer Hitch Installation Tips
- Article: Determining Trailer Tongue Weight
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose the Right Trailer Hitch Class