Trailer Connector Has Current All The Time After Being Moved From 2000 To 2006 Subaru Outback Wagon
Purchased a wiring harness for 2000 Subaru Outback wagon which I later installed on a 2006 Subaru Outback wagon. My question. When the ignition is off should there be any power going through any of the connector terminals, because there is power through one. Thanks,
asked by: Steve
The Tow Ready Custom Fit Vehicle Wiring, part # 118461 is designed to fit both the 2000 and 2006 Outback Wagon as long as it is not a Sport model.
After connecting the T-One harness you should not show any current on any of the pins unless they are activated like stepping on the brake or using the turn signals. If you have all of the connections secure and the key is off and you are showing current on one of the trailer connector pins, there is probably a short in one of the circuits of the ModuLite and the harness will need to be replaced.
Featured Help Information
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Trailer Wiring
- Article: Performance Chips and Modules
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Install a 7-Way and Brake Controller on a 2009 Subaru Tribeca
- Q&A: Can a 4-Pole Trailer Connector Be Used to Activate Trailer Brakes
- Q&A: Replacement Brakes For 2000 Coleman Utah Pop-Up Camper
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Which Vehicles Will Draw-Tite Trailer Hitch 75560 Fit
- Q&A: Will I have to Drill Holes in the Frame to Install Draw-Tite Hitch 75560 on a Subaru Legacy
- Q&A: How to Pick Out Replacement Hubs for Yacht Club Trailer WC112
- Article: Trailer Tire Sizing
- Article: Determining Trailer Tongue Weight