Brake Controller and Installation Recommendation for a 2013 Chevy Tahoe
Products Featured in This Question
Question:
Hellou, Is that system plug n play for Chevy Tahoe 2013 with the 7 way rv connector preinstalled from the factory ? Would you happen to have a guide on how to install that system ? Thank you,
asked by: Veetek
Expert Reply:
Yes, the Curt Venturer Brake Controller # C74VV and the install harness part # C51515 that you referenced are a confirmed fit for a brake controller for your 2013 Chevy Tahoe that has a factory 7-way trailer connector.
No plug is present under the dash, but the needed wires are already run. You will connect the brake controller wiring with the vehicle wiring already present under the dash. See the attached install video.
Product Page this Question was Asked From
Curt Venturer NEXT Trailer Brake Controller - Up to 3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Electric over Hydraulic
- Plug-In
- Under-Dash Box
- Under-Dash
- Up to 3 Axles
- LCD Display
- Single Trailer Only
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Where is the Brake Controller Port on a 2025 Ram 1500
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Q&A: Can etrailer Ball Mount w/ Pre-Torqued 2" Ball be Used in the Rise Position
- Q&A: Recommended Brake Controller For A 2024 Chevy Silverado 1500
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: Curt Echo Full Review
- Q&A: Is an Adapter Needed to Install Curt Venturer on a 2011 Ram 1500 with OEM 7-Way
- Article: Determining Trailer Tongue Weight
- Q&A: Best Trailer Hitch Receiver For Towing With 2018 Toyota Highlander
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector