Would the Pro Series Round, A-Frame Jack # PSEA20000103 fit a 3-1/4 inch Bolt Pattern on Trailer

Question:

I am seeing 3.25inch on center, not 3. Could you tell me which will work to replace my current one. Im hauling a 1972 19inch Terry Trailer. I only need a 1,000lb.

1

Helpful Expert Reply:

The standard bolt pattern for a-frame jacks is 3 on 3 inch. However, if you look at the mounting flange of the Pro Series Round, A-Frame Jack # PSEA20000103 you will see that the mounting holes are slotted and allow for a bit of wiggle room there. An extra 1/4 inch wouldn't be a problem at all.

This jack would work well for you, it has a 2,000 lb capacity so it would work well on your trailer.

Click to Enlarge
helpful expert reply by:
1
Jameson C

Product Page this Question was Asked From


Follow up Questions

What do you think?

* e-mail address format: [email protected]

I would like an email notification if someone replies to my comment

Similar Expert Q&A Pages

See More Q&A Expert Answers >>