Compatibility of Tekonsha Prodigy P3 with 2010 Ford F150 Raptor

Question

Question:

will this unit work on my raptor?

asked by: Michele

1

Helpful Expert Reply:

A brake controller isn't a vehicle specific item. It'll work on just about any vehicle.

If the truck has a 7-way trailer connector, the install will be very simple. You'll access the brake controller connector that's located under the dash to the right of the steering column right next to the OBD port. Once the controller is plugged in using the # 22292 wring adapter and mounted to the underside of the dash according to the installation instructions, you'll be good to go.

If you have the 4-pole, the install will be similar with the controller plugging into the connector described above but at the rear of the vehicle you'll use the # 37185 adapter. The adapter plugs into the existing 4-pole, with the remaining wires connecting as shown in the video I've linked you to.

expert reply by: Mike L

1

Answer 1

Both brake controllers will work with your 2012 Honda Pilot, but let's start with what you need to install them, which is just a couple of components: - 4-Way: T-One Vehicle Wiring Harness #118558 - Universal Installation Kit for Trailer Brake…

view full answer...

Answer 2

The Prodigy P2 brake controller #90885 and the Primus IQ #TK90160 share some basic features, but there are many differences. The most obvious ones are the displays and appearances of the units, which are connected to the usability of the brake…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

view full answer...

Answer 5

The best brake controller option to go with is one that activates the brakes proportionally instead of time delayed. A proportional brake controller will activate the trailer brakes at the same time and with the same intensity as the tow vehicle…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 8

The trailer brakes work on a separate circuit than the lights. You have a couple of options to control the electric brakes on the trailer. One option is to use an air over electric brake control, #HA100400C. This unit connects to the air brakes on…

view full answer...

Answer 9

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 10

There isn't anything like an autonomous controller that would step up if the factory controller fails. I'd simply bypass the existing factory brake controller. The GM ITBC, although it works better now than the earlier models has been…

view full answer...

Answer 11

Hi Frank, While we can get you a brake controller for your 2020 Chevy Colorado, there isn't a plug-in option and harness because the truck doesn't have a plug under the dash. That said, the wires are already run to the cab, so it isn't…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Compatibility of Tekonsha Prodigy P3 with 2010 Ford F150 Raptor

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching