Customers prefer these similar products
Extend the top receiver on your TorkLift SuperHitch dual-receiver trailer hitch to clear obstacles such as your bed-mounted camper. Exclusive, heavy-duty design maintains a high weight capacity and can be used with a weight distribution system.
Features:
Specs:
This SuperTruss hitch extender is specially designed to work with your SuperHitch trailer hitch (sold separately). Like most products from TorkLift, the primary purpose of this extender is to help create a towing setup that fits perfectly with your truck bed camper system. Not only will you be able to extend your trailer hitch receiver out far enough to clear the overhang of your camper, but you will also maintain a high enough weight capacity so that you can tow your trailer.
Most hitch extensions dramatically reduce the towing capacity of your hitch setup, making it difficult to tow a loaded trailer over a certain weight. The SuperTruss, though, creates such a sturdy connection with your SuperHitch trailer hitch that you can still maintain a high weight capacity. To get the highest capacity possible, use a standard weight distribution system with the TorkLift towing setup.
The SuperTruss uses both of the receivers on your TorkLift SuperHitch to ensure a sturdy, secure connection. The solid shank of the extension's top tube slides into your top receiver, and the extension's lower compression tube installs in your bottom receiver. Each tube is held in place with the hitch pins and clips that were included with your SuperHitch. The connection between the extension and your hitch is reinforced with 2 sturdy steel collars that bolt around the tubes of the SuperTruss.
To give you absolute peace of mind, lateral support chains connect to the hitch and the extension on either side of your setup. Just attach one end of each chain to the extension and secure the opposite end to your SuperHitch. Then tighten the chains with the integrated turnbuckles. These chains not only provide extra security to keep the extension in place in your hitch, but they also transfer some of the weight back from the extension to your frame-mounted hitch.
If the camper is mounted on the truck:
Measure from the face of the truck's rear bumper to the outside edge of the camper's bumper. This is the length of the extension that you need.
If the camper is not mounted on the truck:
1. Measure from the inside of the front of your truck bed to the outside face of the truck's rear bumper.
2. Measure the camper's overall floor length from the rubber bumpers at the front to the outside edge of the rear bumper.
3. Find the difference between these 2 figures by subtracting. The difference is the length of the extension that you need.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.