Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks

See what our Experts say about this Swagman Trailer Hitch Lock

• Difference in Dimensions Between P313 and P333 Hitch Receiver Insert for Swagman Bike Racks
  I went out to our warehouse and took some measurements for you. The # P313 Replacement Receiver Insert measures 1.31 in x 0.87 in while # P333 measures a bit smaller at 1.30 in x 0.75 in. See the attached images. # P313 is designed to replace the original insert in these Swagman hitch mounted bike racks: Swagman XC # S64650 Swagman G10 # S64682 (discontinued) Swagman Trailhead # S63360 # P333 is designed to replace the original insert in these Swagman hitch mounted bike racks: Swagman...
  view full answer...
  
• Recommended Trailer Hitch and Cargo Carrier for 2015 Lincoln MKZ
  For your 2015 Lincoln MKZ, I recommend the Draw-Tite Sportframe Trailer Hitch Receiver # 24897. Unlike the Curt model that is also confirmed to fit your vehicle, the installation of this hitch will allow you to trim and reinstall the underbody panel/fascia for accommodation with the hitch receiver and crosstube. On the Curt model, this panel is completely removed and cannot be reinstalled. This Class I hitch will use existing holes in your Lincoln's frame for a no-drill installation....
  view full answer...
• Can the Kuat Anti-Rattle Hitch Pin Be Used W/ a Swagman Bike Rack
  The Anti-Rattle Hitch Lock for Kuat Transfer Bike Racks # HLT is actually going to only work with Kuat bike racks and is not going to work with your Swagman e-bike rack. The only compatible anti-rattle hitch pin is going to be the Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks # S64029 that you already have.
  view full answer...
• Anti-Rattle Device and Trailer Hitch Lock for Swagman S63400 2 Bike Carrier
  If you are using the Swagman 2 Bike Carrier, # S63400, in a 2 inch trailer hitch receiver, you can use the locking Anti-Rattle Device # S64029. This device will keep the rack from rattling in the hitch.
  view full answer...
• Troubleshooting The Swagman XTC 2 Bike Rack With 2 Inch Hitch Adapter
  If you used the adapter that came with your Swagman XTC-2 2-Bike Platform Rack for 1-1/4" and 2" Trailer Hitches # S64670, the threaded pin will work for use with or without the adapter. There is a specific way to install that adapter, so I wonder if you have it switched because one hole is bigger than the other hole on that part, so reversing it could cause the issue it sounds like you are hitting. I suggest swapping the direction of those holes and trying the pin again. If you want...
  view full answer...
• Installation of Swagman Threaded Hitch Pin for Swagman Bike Racks
  The Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks # S64029 comes with both the flat washer and the lock washer. I recommend putting the split lock washer on first and then the flat washer then insert the pin into the hitch. This will allow the split lock washer to compress flat to keep the bolt tight while protecting your hitch receiver from damage from the washer digging into the powder coat finish. The lock cylinder will connect to the opposite side of the hitch pin...
  view full answer...
• Will Swagman Receiver Insert # P313 Fit Within a Swagman Bike Rack Shank
  After speaking to my contact at Swagman, I have found the Swagman Replacement Receiver Insert # P313 will fit within the hollow shank of a Swagman bike rack such as the Swagman XC Bike Carrier # S64650 or the Swagman Replacement 1-1/4-inch or 2-inch Shank # P306. This particular Swagman Replacement Receiver Insert is intended solely for other applicable Swagman products. We do sell the bolts and we also sell cable locks that would work with any bike rack you choose. The bolt I recommend...
  view full answer...
• Replacement Threaded Hitch Pin And Clip For A Swagman XTC2 TILT Bike Rack
  You can replace the threaded pin and clip for your Swagman XTC2 TILT Bike Rack for 2 Bikes # S64671 with part # P5902 or you can upgrade to the Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks # S64029 to ensure that no one can take of with your bike rack.
  view full answer...
• Recommended Bike Carrier Options for 2015 Hyundai Sonata
  The design of your 2015 Hyundai Sonata does not lend itself to trunk-mount type bike racks. In fact both Thule and Yakima do not recommend any of their trunk racks for your Sonata. So, your best option is to install a Class I hitch and use a hitch-mount bike rack. However, note that a Class I hitch can handle the weight of only 2 bikes. The hitch I recommend for your Sonata is the Draw-Tite # 24965 because it installs without drilling and includes all the required hardware to bolt it on. You...
  view full answer...
• Using an Anti-Sway Accessory on a Swagman XTC-2 2-Bike Platform Rack
  For your Swagman XTC-2 2-Bike Platform Rack, # S64670, the rack comes with a threaded hitch pin that should keep the rack secure and limit the movement of the shank within the receiver. I've linked a video that shows this pin at the 1:40 mark. If you need to replace this pin, your best option would be the 1/2 inch Locking Anti-Wobble, Threaded Hitch Pin, # S64029. If you choose to, you can use an additional anti-sway accessory. There are limited fits for a bike rack, but I have a couple...
  view full answer...
• Locking Hitch Pin Recommendation for Swagman XTC-2 Bike Rack on a 2018 Mazda 3
  Yes, the Draw-Tite Sportframe Trailer Hitch Receiver # 24914 for your 2018 Mazda 3 Hatchback is compatible with the Locking Anti-Rattle, Threaded Hitch Pin # S64029 that you would use to lock the Swagman XTC-2 # S64670 to your trailer hitch. If you wanted to incorporate a cable lock as well for your bikes then you would need part # S64031 instead. Attached are some installation and review videos for you to check out too.
  view full answer...
  
• Swagman 2 Bike Carrier # S64650 Recommendation for a 2008 Honda Fit
  In order to determine if this Swagman 2 Bike Carrier, part # S64650, will work on your 2008 Honda Fit that has a 1-1/4 inch hitch you will need to make one, easy measurement. You will need to measure the distance from the center of your hitch pin hole out to the furthest point on your bumper. If this measurement is less than 10-1/2 inches this rack will work for you. The reason is because the distance from the center of the hitch pin on this rack to the edge of the first wheel hoop is...
  view full answer...
• Swagman Locking Anti-Rattle Device # S64029 Recommendation for a Swagman XTC2 Bike Rack # S64670
  For your Swagman XTC-2 # S64670 you could use the Swagman Anti-Rattle Locking Hitch Pin and Cable # S64031 that you referenced. If you wanted it without the cable you could get a Swagman Locking Anti-Rattle Device # S64029.
  view full answer...
• Suggestion For Swagman XTC2 Bike Rack With Threaded Hitch Pin Not Long Enough To Secure With Clip
  I do see where you got the Swagman XTC2 Bike Rack # S64670 and Threaded Hitch Pin # P5902 from us in the past. That pin is designed to fit most 2" receivers as well but there are some vehicles where the hitch is slightly larger and it will not clip properly. We do have the Locking Hitch Pin # S64029 which has a much larger 4-3/8" span so you know it will fit your receiver. The pin you have only has a 2-7/8" span.
  view full answer...
• Locking Anti-Rattle Hitch Pin Fit for a Swagman XTC2 TILT Bike Rack
  To lock the Swagman XTC2 TILT Bike Rack # S64671 to your etrailer Trailer Hitch Receiver # e98843 you need the Locking Anti-Rattle, Threaded Hitch Pin # S64029 you referenced, but I actually recommend picking up the Anti-Rattle Hitch Lock and Cable # S64031 instead because it comes with the same locking hitch pin as well as a cable that connects to the hitch pin to provide security both to your bike rack and the bikes you'll have loaded on it.
  view full answer...
• Bike Rack Recommendation to Clear My Bumper with the Curt Hitch # C12239 on a 2008 Buick LaCrosse
  When considering whether you have enough shank length on a bike rack to clear your rear bumper, the only way to know for sure is by measuring the center of the hitch pinhole to the outside surface of your rear bumper. We unfortunately do not have that measurement available for the Curt # C12239 when installed on your vehicle. However, since we do have that measurement available for the Draw-Tite # 36374 on a 2009 model Buick LaCrosse, you most likely do not have enough clearance length...
  view full answer...
• Replacement Cable Lock for Swagman XC 2-Bike Rack Platform Style
  Yes, the cable lock for the Swagman XC 2-Bike Rack Platform Style part # S64650 can be purchased separately using the Replacement Cable for Swagman Bike Rack and Hitch Locks part # S2005 which is designed to be used with the Locking Anti-Rattle, Threaded Hitch Pin for Swagman Hitch Racks part # S64029.
  view full answer...
• Availability of Anti-Rattle Device for Bike Rack Installed in 1-1/4 Inch Hitch Receiver
  When the hitch is manufactured, the receiver tube can actually be a tiny bit larger than 1-1/4 by 1-1/4 inches, but still within tolerance. The shank of the bike rack can actually be a tiny bit smaller than 1-1/4 inch by 1-1/4 inch, but still be within tolerance. This is what causes the movement you're experiencing. What you're needing is what's known as an anti-rattle device. for this Swagman Titan # S63400 bike rack, you will need the , Locking Anti-Rattle, Threaded Hitch Pin for Swagman...
  view full answer...
• Is There a Locking Hitch Pin for the Swagman Titan 2-Bike Rack
  The Swagman Titan 2-Bike Rack for 1-1/4" and 2" Hitches part # S63400 can use the Locking Anti-Rattle, Threaded Hitch Pin part # S64029.
  view full answer...
• Why Is the Inno Tire Hold 2 Not Compatible with a Motorhome?
  I have a great solution for you. The reason why the Inno Tire Hold 2 # INH120 will not work with your 2016 Thor Outlaw Motorhome is because the construction of the rack cannot withstand the extra forces/torque that is exerted on the rack when mounted on the back of the vehicle. When your motorhome goes over bumps/makes turns, the forces exerted on the rack increase exponentially in comparison to a shorter vehicle. Unfortunately, there is no adapter that will be able to solve this issue....
  view full answer...
• How Does Cap of Swagman Locking Anti-Rattle, Threaded Hitch Pin Lock Onto Pin
  All you have to do is replace the cap on the Locking Anti-Rattle, Threaded Hitch Pin # S64029 and it will snap back on the pin in the locked position. Obviously you'll need the key to remove it. Attached is a review video for you to check out. The guy in the video leaves the key in when he puts the cap back on but you can very well remove the key prior to doing so.
  view full answer...
• Will Swagman XTC-2 TILT 2-Bike Rack Work With Bike With Thicker Tube
  Your bike that has a thicker tube will fit on the Swagman XTC-2 TILT 2-Bike Rack # S64671. The frame hooks of the XTC-2 will easily accommodate that size of tube, and will retract down far enough in order to grasp the frame. You will need to place your bike at the inside position - nearest your vehicle - in order to use it though, as this is the hook that will go down the furthest. I do recommend adding locks for this rack to help protect your investment. To lock the rack to your hitch...
  view full answer...
  
• What Grade Steel is Swagman Locking Hitch Pin 64029 Made Of
  I spoke with my contact at Swagman and I have the following information on locking hitch pin # S64029. The pin is constructed of 1008 steel and has heavy chrome plating. It is also 12 UNC Coarse threaded. It is designed for Swagman bike racks and would not work with accessories that are threaded differently.
  view full answer...
• Will the Thule Gateway Trunk Mount Bike Rack Fit a 2012 Subaru Legacy with Factory Spoiler
  If the spoiler on your 2012 Subaru Legacy is the small, low-profile type then you can install the Thule GatewayPro, # TH88VR. If you have a hatchback/wagon with the spoiler at the top OR you have a spoiler on a sedan that has a gap between the trunk lid and bottom of the spoiler then a trunk mount bike rack will not fit. If this is the case, you would be best served by installing a receiver hitch like part # 75673 and using a hitch-mounted bike rack. The Swagman Titan, part # S63400 would...
  view full answer...

Do you have a question about this Trailer Hitch Lock?