Replacement Namsco Wheel Cover - 19-1/2", 10-Lug Wheels - 10 HH - Rear - Qty 1

Video Transcript for Replacement Namsco Wheel Cover Review

Jeff: Hello everybody. This is Jeff at etrailer.com. Today we're going to take a look at this replacement, stainless steel, rear wheel cover for the 19 and a half inch diameter, 10 lug wheels. And this is for a quantity of one cover. Now this replacement wheel cover will fit over a wheel on the rear of your vehicle. It is a nice low profile, aerodynamically designed and covered.

It'll deliver a nice sleek look on your vehicle. It is made of a 304 stainless steel construction, very sturdy and rustproof, and you can see has a nice mirror finish, gives you a nice clean eye-catching shine to your wheel.Now it does come with all the mounting hardware you need for installation. Nice set of instructions. And this model does include a retention system that'll firmly hold the wheel cover centered on your wheel, preventing any wobble.Basically, when you go to install this, what you do is go to the rear axle and you'll remove two of the axle nuts from the axle hub that are across from each other. And then you'll install this rear bracket.

These holes on rear bracket will go over those two bolts. And then re-install the two axle nuts to hold this rear bracket into place.So with this being on your hub, now, then what you'll want to do is on the wheel cover, you'll see this little center cap in the middle here. You can actually pop that out. There's three prongs on it. So if you pop that out, then you'll have access to the center of the wheel cover.

And you'll notice the two holes here. So what you're going to do with this being mounted onto your hub, and then you put your wheel cover onto your wheel. This'll line up pretty much just like that. And then what you'll do is take this anti spin bracket and put it through the two holes on the wheel cover. And then those two holes will line up with the two holes that'll be on your bracket, just like that.And then with it on there, then you just take your screw, this longer screw, and then you'll go ahead and put it through there and tighten it down and tighten it all the way till the wheel cover doesn't move.

And then with it all tightened up, all you'll have to do then is just take your cap, line the holes up. Once you get the holes lined up, then just pop it into place and that'll cover the installation brackets. You can't even tell how it's installed. So it's a very simple installation, very easy to do. Comes with all the hardware and brackets you need, and as I mentioned, a nice set of instructions.Now these lug covers right here, they also can be popped out. There's just four prongs on those. You can pop those out, if you need to access the lug nuts.A few specs on this again. The application, it fits 10 lug wheels. The wheel diameter it fits is 19 and a half inches. Now this will not fit an eight lug wheel or the older split rim design wheels. And it is for a quantity of one wheel cover. And if you notice the design, it has the 10 hand holes all the way around.But that should do it for the review on this replacement, stainless steel, rear wheel cover for 19 and a half inch diameter, 10 lug wheels.