Replacement Control Module for Lippert Ground Control 2.0 Electric Leveling System

See what our Experts say about this Lippert Accessories and Parts

• Replacement Control Module for Lippert Ground Control 2.0 17410
  The number you mentioned corresponds with a Lippert Ground Control 2.0 so for a control module replacement you would want the part # LC242623.
  view full answer...
• Correct Replacement Control Board for the Lippert Ground Control 2.0 On a 2011 Landmark
  The correct control module for your 2011 Landmark is the Replacement Control Module for Lippert Ground Control 2.0 Electric Leveling System # LC242623.
  view full answer...
• Replacement Module for Lippert Ground Control 2.0 307296
  Since you have the Lippert Ground Control 2.0 with the module number 307296 the correct controller is the part # LC242623 that you referenced.
  view full answer...
  
• LF Error on Lippert Ground Control 3.0 4-Point Set
  I checked with Lippert, and the error like the LF error you are getting on your Lippert Ground Control 3.0 - 4-Point Set # LC358590 is typically caused by a wiring interruption. So according to them, you'll want to check the harness connections at your controller as well as the jack to see if they are fully seated and for any damage, and also check the fuses at the controller. Otherwise, should there be damage on either you will need replacements (depending on what is damaged): - Replacement...
  view full answer...
• Replacement Controller for Lippert Hydraulic Level Up System
  The replacement control panel part # LC421484 is the correct control panel for the Lippert Hydraulic Level Up system you most likely have. If you were looking for something different or if you have a different system let me know.
  view full answer...
• Testing Wires of Lippert Ground Control to Determine If Issue is With Controller or Touch Pad
  I sent all of this to my tech contact at LCI to see what they this is the problem and they were able to come up with a way to use the voltage readings to determine where the issue is: There are 4 wires on the harness as follows Black= power (need to see 12 volts) Green= ground Yellow= signal wire (need to see 5 to 9 volts) Red= signal wire (need to see 5 to 9 volts) If voltage coming into controller is 12 volts but less than 12 volts at touch pad we have a bad controller, # LC242623. If...
  view full answer...
• Replacement Controller for Rieco Titan 300898 Leveling System
  Thanks for the picture! That's definitely the same controller as our part # LC242623 so this would be exactly what you'd want.
  view full answer...
  
• Troubleshooting Lippert Ground Control System Showing Jack Errors For all 4 Jacks On 5TH Wheel
  It sounds like you have a wiring issue with your Lippert Ground Control system. Since all your jacks are showing as error you will want to start by checking the wiring going into the main Control Module # LC242623 located inside your Camper. This is typically located in the front storage area near the landing gear but you can follow the wiring from your Control Panel # LC421484 to locate it. You can also use a spare battery to test the jacks individually by disconnecting them from the control...
  view full answer...
• Replacement Control Module for 14155-C for Landmark 20
  The correct replacement you are looking for is the Replacement Control Module part # LC242623.
  view full answer...
• Which Controller to Use For Ground Control 4-Point Leveling System
  The Replacement 4-Point Controller for Lippert Components Ground Control 2.0 Electric Leveling System # LC242623 is not the same as the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System # LC304136. Although they look similar there are differences and are not interchangeable. The connections are different even though the jack connections appear similar. The 307296 you reference is a part that according to my contact at Lippert is a new part they added to...
  view full answer...
• Control Panel that Can be Used with Replacement Control Module # LC242623
  The module part # LC242623 does not come with a control panel. If you'd need that as well you'd need the part # LC421484.
  view full answer...
• Troubleshooting Ground Control 2.0 Touchpad Not Working for Manual Extension of Rear Legs
  Hi Gary; since the legs work for auto leveling the problem is the signal being sent. What you need to do is take a tester like # PTW2993 and check the wires at the touchpad for proper voltage. The red and black as well as yellow and black wires should have 4 to 9 volts. If it is higher or lower you need to replace the touchpad with the # LC421484. If the touch pad checks out then the only thing left is the control module which can be replaced with # LC242623.
  view full answer...
• Can The Touchpad Of A Ground Control 3.0 Leveling System Be Swapped Out For A Different One
  Hey Eric, Do you only have the OneControl touchscreen inside your trailer or do you also have a separate controller on the outside or in an exterior compartment? You should have a controller that looks like either the # LC421484 or # LC74FR. If not can you send me a picture of the control module you currently have and any part/serial numbers it has listed on it?
  view full answer...

Do you have a question about this Accessories and Part?