To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Quickly and easily install a 4-way trailer connector on your vehicle with this custom harness. T-connector plugs directly into existing wiring. Powered converter reduces strain on wiring system.
Features:
This custom-fit T-connector plugs into your vehicle's wiring harness, which is located behind the driver's-side and passenger's-side tail lights. You will have to remove the rear threshold, some interior paneling, and the tail light assemblies to access this harness. Once you've plugged in the connector, run the red hot lead up to your car battery. Connect the included fuse holder, and then connect the fuse holder to the positive terminal on your battery.
Once installation is complete, the 4-way flat connector will be stowed in your rear cargo area.
It is recommended that you use a small amount of grease on all electrical connections - the plugs on your automobile and the 4-pole connector itself - to help prevent corrosion.
A tail light converter is built into this T-connector. This converter is a battery-powered unit that bypasses the electrical routes that are used by a basic wiring harness. As a result, there is virtually no draw on your tail light circuits.
Because most trailers run on a two-wire system - wherein the brake and turn signals are carried on one wire - the separate brake and turn signals from your vehicle's three-wire system need to be combined so they are compatible with the wiring system of the trailer. This converter combines the brake and turn signal functions of your automobile so that they run on one wire to properly activate your trailer's tail lights. Note: This will not affect how the tail lights on your vehicle operate.
California residents: click here
Received the wrong wiring harness. The one I first received was for the Sienna SE, not the XLE. Costumer service sent me the return label and the correct wiring harness. Once I received the correct one the hardest part was finding a good ground. I think I wired it to the jack mount and put the control box in the same cavity. The wires come out of the hole in the plastic next to the trunk latch. It works great!
Looks great, have not installed yet.
Tried to mount module on right side of trunk but left side light wire was the short one so had to cut and resolute the left and right side light harnesses and the wire provided for getting to the battery was to short but otherwise worked fine. 2011 sienna xle.
simple install and works flawlessly.
Great product
Order arrived before the due date, was very well packaged, no damage to anything,am very impressed!! Thank you!!!
Very knowledgeable and excellent service. I would definitely recommend it to my friends.
ok
Do you have a question about this Custom Fit Vehicle Wiring?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Ralph
2/28/2022
Working great. No problems.