Triple-Axle Trailer Equalizer Kit for 2" Slipper Springs - 10-1/8" Long Equalizers

Video Transcript for Let’s Check Out the Triple-Axle Trailer Equalizer Kit for 2" Slipper Springs

Today we'll be taking a look at the triple-axle trailer equalizer kit for two-inch slipper springs. Our equalizers are going to take out some of that brunt of force whenever we're going down the road and you hit a bump. Typically, one of your axles would be in the air and then the rest of the weight would be coming down fully on the remaining axles. This helps to distribute that weight, so we don't have any one axle getting overloaded. That helps to maintain better longevity with our axles, make sure that we don't overload any components of our system, and it also helps to make our ride more comfortable in our vehicle while we're towing down the road.Our kit comes with the four equalizers. These are a swan-shaped equalizer that measures 10-1/8 inch, and that's going from the center of the shackle bolt hole here at the end to this little fin that comes up on the top.

They have a two-inch inner channel to fit with our two-inch slipper springs, so you have a little bit more than two inches on the inside edge there to allow those springs to fit in place. We'll also have our four, 7/8-inch diameter bolts. Those are going to measure 4-1/2 inches long, and they have the little grease Zerk on the end so those are wet bolts to make sure that we have good lubrication inside there. Keeps everything working smoothly. And then we'll also have our 7/8-inch lock nuts on the end of each one of those bolts.

So that'll keep everything in place in its center.We'll have six, 9/16-inch diameter shackle bolts. These are going to measure 3-1/2 inches long. Those will be mounted onto the end here to match up with our spring. And then we'll also have the 5/16-diameter bolts to mount to our spring keeper. Those measure 3-1/4 inch long.

And then we'll also have our lock nuts to go with those.The distance from our center hole to the back mounting hole there is about 4-5/8 inches, center to center. And the distance from that center hole to the spring keeper is about five inches.Now, if you pick up part number H302, that contains the front, center, and rear hangers. That will make this a complete kit to get everything installed. That H302 is sold separately here at eTrailer.com if you want to pick that up. And this is designed for use on trailers with triple axles that have a 3,500-pound to 8,000-pound capacity.And that's going to do it for our look at the triple-axle trailer equalizer kit for two-inch slipper springs..