Takeda
Expert Answers about Takeda
- How to Clean Takeda Pro Dry S Performance Air Filter # AFETF-9006D
- I spoke with my contact at AFE and he said you can use dish soap or hand soap to wash the Takeda Pro Dry S Performance Air Filter, part # AFETF-9006D. He mentioned after washing that you should let the filter air-dry and not use compressed air to dry the filter.
He also recommended a better option to clean the Pro-Dry filter is to use the Restoration Kit for AFE Pro Dry S Air Filter, part # AFETP-7015C. This has a cleaning solution that is sprayed on the filter and rinsed with water...
view full answer... - Direct Fit Cold Air Intake for a 2008 VW Rabbit with 2.5 liter Engine
- As long as your 2008 VW Rabbit has the 2.5 Liter Engine in it, the Takeda Attack Direct-Fit Cold Air Intake System with Pro Dry S Filter, # AFETA-6002B, will be a direct fit installation and will not require any modifications or cause the check engine light to come on, as long as it is properly installed.
We also recommend using the Restoration Kit, # AFETP-7015C, for aFe Pro Dry S Takeda Air Filters, to keep the filter clean and the filtration fibers in good condition.
view full answer... - Cold Air Intake Recommendation for a 2007 Mazda 3 Sedan 2.0L
- The Takeda Attack Direct-Fit Cold Air Intake System, # AFETA-4107P, is designed to fit the 2010 and 2011 Mazda 3, 2.5 Liter. For your 2007 Mazda 3 sedan 2.0 Liter you will need the Takeda Retain Direct-Fit Short-Ram Cold Air Intake, # AFETR-4101P.
I have attached installation instructions for your air intake system for you to check out.
view full answer... - Check Engine Light Came on After Installing Cold Air Intake on a 2007 Mazda 3
- Cold air intake that is the right fit for a given vehicle is supposed to fit in the same area as the stock intake. The filter near the wheel, if that is not where it is supposed to be based on the stock set up, could cause some issues. But your problem is likely different.
An upgraded intake is going to suck in more air meaning that the fuel to air ratio is different than stock. This is likely what is causing the error. If you were to run diagnostics on your 2007 Mazda 3 you would probably...
view full answer... - Does the Takeda Pro Dry S Performance Air Filter # AFETF-9006D Affect Oil Change Intervals
- If you install the Takeda Pro Dry S Performance Air Filter # AFETF-9006D it will affect how often you change air filters (you'll never have to again), but as far as engine oil changes go there will be no change. You will still want to change the oil at the vehicle manufacturers recommended interval. Usually 3,000 miles.
You may not need to replace the air filter ever again but you will need to clean it.
I spoke with my contact at AFE and he said you can use dish soap or hand soap...
view full answer... - Recommended Takeda Air box for 2010 Honda Fit RS GE8 L15A
- I have a custom fit Takeda air box for your 2010 Honda Fit, but it isn't the # AFETM-1016P you were looking at.
The # AFETA-1003P is the correct Takeda direct-fit cold air intake system for your Fit track car, so no need for modifications. This unit comes with the Pro Dry S Filter. It is designed to draw from your vehicle's lower grille for a cooler charge of air, resulting in lower engine temperatures and improved performance.
Some other performance parts for your car from AFE...
view full answer... - Is Takeda Attack Direct-Fit Cold Air Intake System # AFETA-1006P Legal for Emissions Requirements
- The Takeda Attack Direct-Fit Cold Air Intake System, # AFETA-1006P, does not have emissions restrictions so it is legal. This intake system will fit your 2006 Honda Accord as long as it has the 3.0 liter engine. Consult your local and state laws regarding any aftermarket component additions and the legality of use. I have included a link to the installation details for you.
view full answer... - Takeda Cold Air Ram Air Intake System Recommendation for a 2008 Mitsubishi Lancer GTS
- I did some research and everything I found says that the 2008 Mitsubishi Lancer GTS models are powered by a GEMA based 4B11 that is a 2.0 liter DOHC engine producing around 150 hp.
If you have the stock engine in your vehicle then this Takeda Retain Direct-Fit Short-Ram Cold Air Intake System # AFETR-4201P should work very well for you.
If you have an engine in your vehicle that is not the original I would not be able to recommend an intake for you since there would be too many variables.
I...
view full answer... - Does Adding aFe Cold Air Intake Void the Warranty on a 2010 Honda Accord 3.5L
- Consumers are protected by the Magnuson-Moss warranty act that states in part that unless the part added actually causes a problem then installation and use of the part will not void the warranty.
The system does have an input for the mass airflow sensor which should be the only sensor that was on the factory intake.
view full answer... - Installation of Takeda Short-Ram Cold Air Intake System AFETR-3006P on 2013 Nissan Cube
- Installation of the custom-designed Takeda Retain Direct-Fit Short-Ram Cold Air Intake System # AFETR-3006P is simple enough that mechanically-inclined users who have the correct tools can usually handle the installation without issue. If you can see how the stock intake is mounted and you can remove those fasteners without a problem then installing the Takeda should not be any more challenging.
This intake is a confirmed fit on your 2013 Nissan Cube with 1.8L inline 4 engine. It is...
view full answer... - Mass Airflow Sensor Reads Incorrect Levels with Takeda Direct-Fit Cold Air Intake # AFETR-2001P
- The aFe Takeda Retain Direct-Fit Short-Ram Cold Air Intake System # AFETR-2001P that you installed comes with a precision-tuned mass airflow (MAF) sensor pad to prevent false "check engine" warning lights from the increased oxygen levels. Please refer to the linked photo. Make sure that your MAS in is installed correctly to this component.
view full answer... - Best Cold Air Intake for a 2005 Infiniti G35X Sedan in California
- As far as I could find, there aren't any restrictions for intake parts in the state of California so you can use cold air intake # AFETR-3001B. it does fit a 2005 Infiniti G35x sedan with a 3.5 liter V6 engine. The only restriction is that it will not fit models that have a circular mass air flow sensor.
view full answer... - Does Takeda Cold Air Intake for a 2014 Infiniti Q60 Come with or Need Heat Shields
- Takeda Retain Direct-Fit Short-Ram Cold Air Intake System # AFETR-3008P does not come with heat shields because they are not necessary for this application. They are not close enough to anything that would get hot enough to cause any damage.
view full answer... - Does Takeda Cold Air Intake # AFETA-1006P Increase Gas Mileage
- We do not have official test results but in almost all cases the addition of a cold air intake like the Takeda Attack Direct-Fit Cold Air Intake System with Pro Dry S Filter # AFETA-1006P gives any where from 1 to 3 more miles per gallon.
view full answer... - Using Simple Green Cleaner on Takeda Pro Dry S Intake Air Filter
- You can indeed. If using Simple Green, Takeda recommends using an 8:1 ratio of water to cleaner.
Takeda also offers a cleaner, part # AFETP-7015C.
view full answer... - Will Takeda Direct-Fit Cold Air Intake # AFETL-1002P Fit 2009 Honda Accord 2.0 Liter Engine
- The Takeda Direct-Fit Cold Air Intake # AFETL-1002P that you referenced is intended specifically for the Acura TSX with 2.4L inline 4 engine. It fits model years 2009 through 2012. This item does not fit the Honda Accord with 2.0L engine.
If your 2009 Accord is a European model not intended for the U.S. market then you will need to check for aftermarket parts intended specifically for that version.
We do offer aftermarket cold air intakes for the U.S. edition of the 2009 Honda Accord...
view full answer... - Cold Air Intake Recommendation for a 2010 Toyota Corolla
- The Takeda Retain Direct-Fit Short-Ram Cold Air Intake System # AFETR-2006P that you referenced will fit your 2010 Toyota Corolla regardless of if you have a manual or automatic transmission.
view full answer... - Will AFE Link Intake System with Pro Dry S Air Filter Effect Emissions
- I spoke with my contact at AFe and he said the Advanced FLOW Engineering Direct Fit Takeda Link Intake System with Pro Dry S Air Filter, part # AFETL-2002P, will have no effect on emissions, and will in fact increase airflow up to 85 percent. The part is not yet California Air Resources Board (CARB) certified, however certification is pending.
view full answer... - Does AFE Cold Air Kit part # AFETA-1003P Fit Honda Fit with 1.5 liter
- If your Honda Fit is between the years 2009 and 2013 the part # AFETA-1003P will fit as it is a fit for those years with the 1.5 liter I4 engine.
view full answer...
What our customers are saying:
Fast service, fast shipping, received all the correct parts I ordered. Thank you for the great service.
Brian
St. Cloud, MN