1. Trailer Parts
2. Truck Bed Step

The only possible option we have that would work with your 2023 Ford F-150 without LED's is the Curt item #C75WR. This custom fit T-connector plugs in behind your tail lights but only works if your truck came from the factory with a…

Hi Corey; the BAKFlip MX4 Hard Tonneau Cover #BAK48204 weighs 71 lbs. There are several different Extang 2.0's so I'm not sure which one you had. Using a 2019 2500 the Trifecta Signature 2.0 #EX94430 weighs 35 lbs and so does…

The BAKBox 2 Collapsible Truck Bed Toolbox #BAK92201 will be in a fixed position once installed. The bolts for the brackets are tightened down on each side to keep the toolbox in place. You can install it anywhere along the rails underneath the…

Hey Chris, The Yakima RuggedLine HD Mounting System for LockNLoad Platform #Y43DJ is not compatible with a 2021 Toyota Highlander unfortunately. If you have flush mounted rails that run from front to back then you could go with the following…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The HitchMate TireStep #HE4040 does not have any additional parts intended to protect your vehicle's rim. However, we haven't had any customers experience this issue using it. Another option is the Powerbuilt Adjustable Tire Step…

The battery you use for a break away system needs to be able to power the trailer brakes on full for 15 minutes. A 12 volt battery rated for 5 amp hours is normally used, unless you have 3 axles each with brakes, then you would benefit more from a…

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

I spoke with Curt about the Curt Q25 5th Wheel Hitch and was informed that they do not offer the locking jaw mechanism as a replacement part. I know this is not what you wanted to hear but the fact remains. That said, if you want you can replace…

In regards to the Hopkins Engager Push-To-Test Trailer Breakaway Kit part #20099, the first issue that you described of the yellow charge light being on even while disconnected from the tow vehicle could either be a short in the circuit board or if…

A typical tire inflator will have a CFM rating of around 1.5 to 2 CFM, with a majority of the little cheap ones being less than 1 CFM. The higher the rating the faster you'll be able to air up the tires. The Viair Automatic Portable Air…

For an RV ladder that has a hinge half way up the ladder we have the Stromberg Carlson #LA-401 which would work well for you. The hinge allows the lower portion to fold like you are wanting so that it can match an angled RV wall like in the picture…

The only possible option we have that would work with your 2023 Ford F-150 without LED's is the Curt item #C75WR. This custom fit T-connector plugs in behind your tail lights but only works if your truck came from the factory with a…

Hi Corey; the BAKFlip MX4 Hard Tonneau Cover #BAK48204 weighs 71 lbs. There are several different Extang 2.0's so I'm not sure which one you had. Using a 2019 2500 the Trifecta Signature 2.0 #EX94430 weighs 35 lbs and…

The BAKBox 2 Collapsible Truck Bed Toolbox #BAK92201 will be in a fixed position once installed. The bolts for the brackets are tightened down on each side to keep the toolbox in place. You can install it anywhere along the rails underneath the…

Hey Chris, The Yakima RuggedLine HD Mounting System for LockNLoad Platform #Y43DJ is not compatible with a 2021 Toyota Highlander unfortunately. If you have flush mounted rails that run from front to back then you could go with the following…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The HitchMate TireStep #HE4040 does not have any additional parts intended to protect your vehicle's rim. However, we haven't had any customers experience this issue using it. Another option is the Powerbuilt Adjustable Tire…

The battery you use for a break away system needs to be able to power the trailer brakes on full for 15 minutes. A 12 volt battery rated for 5 amp hours is normally used, unless you have 3 axles each with brakes, then you would benefit more from a…

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

I spoke with Curt about the Curt Q25 5th Wheel Hitch and was informed that they do not offer the locking jaw mechanism as a replacement part. I know this is not what you wanted to hear but the fact remains. That said, if you want you can replace…

In regards to the Hopkins Engager Push-To-Test Trailer Breakaway Kit part #20099, the first issue that you described of the yellow charge light being on even while disconnected from the tow vehicle could either be a short in the circuit board or if…

A typical tire inflator will have a CFM rating of around 1.5 to 2 CFM, with a majority of the little cheap ones being less than 1 CFM. The higher the rating the faster you'll be able to air up the tires. The Viair Automatic Portable Air…

For an RV ladder that has a hinge half way up the ladder we have the Stromberg Carlson #LA-401 which would work well for you. The hinge allows the lower portion to fold like you are wanting so that it can match an angled RV wall like in the picture…