1. Home
2. Trailer Parts
3. Recovery Gear
4. Tree Saver Straps

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

I am far from an expert on snowmobiles but one would have to think such a large truck with the correct tires and chains would be able to make it through up to 2' of snow assuming you have clearance on the vehicle. In regards to the type of tire…

Since tire chain fits are pretty specific and there's such a wide range of tire sizes there ends up being a bit of overlap for some sets of chains. This is the case for the two Titan chains you mentioned of #TC2327 and #TC2533 mostly but there…

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

Choosing the correct replacement cable and pin for your 20005 and 20014 Hopkins breakaway switches will depend on the style of key that they accept. Hopkins changed the style of keys that their breakaway switches accept, but kept the part numbers the…

For The ComeUp Seal Gen2 Off-Road Winch - Wireless Remote - Synthetic Rope - Hawse Fairlead - 16,500 pounds #CU295660 per the manufacturer to run a 20 foot run of cable they would recommend 00 (2/0) AWG.

I'm assuming you have hydraulic drum brakes and actually need the brake actuator. If that is the case, you're looking at either extending the tongue so you can bolt on an actuator like the #DX33FR or welding one on like the #DEX94FR. Both…

The hole diameters for the Demco Channel Tongue Trailer Coupler item #12564 are 1/2 inch. It is recommended to use grade 8 hardware to attach the coupler to your trailer frame. You can find these bolts at a local hardware store as they do not come…

As shown in the provided photo, the approximate distance from the centerline of the trailer ball to the end of the coupler is 12 inches. The Demco #12564 accepts a 2 inch trailer ball.

First you would need an engine oil cooler kit. I recommend #D15502 because it comes with multiple thread types and has the proper O-ring size for a V-6 Toyota motor. The sandwich adapter included is thermostatic so a separate thermostat is not…

Yes, it is! The Gen-Y Hitch Pin and Clip for 2" Hitches item #325-GH-096 will work with all 2" receiver hitches and is rated for the extra weight of a class IV or V hitch.

The correct hub/drum for a Dexter 4,000 Lb Axle is the Dexter Trailer Hub and Drum Assembly part #K08-426-91. Then for the brakes, you can use the Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-468-469. The hubs/drums for a 3,500 lb axle are…