1. Home
2. Trailer Parts
3. Trailer Tool Box
4. 24 Inch Longx
5. Steelx

Hey Sean, From the bottom of the etrailer Trailer Tool Box #e44VV to the bottom of the gas strut bracket is right at 19". There's also the latching mechanism on the front of the box that sticks out inside the box that that's about…

Hello Jim, thanks for reaching out. We do have a hitch mounted carrier that works great for mobility scooters. Take a look at the Erickson Aluminum Mobility / Cargo Carrier #EM34JV. This is made of aluminum so it is strong and lightweight. It has a…

Hey Tom, yes the Erickson Cargo Carrier part #EM34JV would work great for you as it has the needed clearance to fit past the rear of your RV as well as has the needed weight capacity.

Hey Linda, thanks for reaching out! Yes, the Erickson Aluminum Mobility / Cargo Carrier #EM34JV uses an M16 threaded bolt for the hitch pin. Are you looking to replace it, or are you trying to get on in advance? (This already comes with one)

We have seen people mount storage boxes on either side of the nose of a V-nose trailer like what you see in the picture I attached. The part #DZ91717P would work well if you have room for it like that. The dimensions of the box are 36" long…

These toolboxes do not contain mounting hardware due to the different construction and mounting locations that may be required for many different styles of trailers. A lot of how you install the UWS A-Frame Trailer Toolbox #UWS01065 depends on where…

...trailer owners due to the fact that it weighs less (only 28lbs). In comparison, the UWS is also aluminum so it is lightweight at 31.5lbs, while the RC is steel weighing in at 68lbs....

...Aluminum folding rear cargo rack. Do you carry this item. Steel doesn’t work because we are on the beach...

...Hey Frank, on the etrailer box part # e64VV all of the walls are welded. The thickness of the steel is 13 gauge. What will you put in the box...

Hey Rod, The Ark Xtreme Off-Road Jack w/ 2 Wheels #ARK99FR has multiple slots in the outer tube of the jack that the mounting bracket can slot into. In the bottom slot you'd be right around 9-1/2" between the ground and frame with the wheels…

Hey Frank, 2" hitch balls like what you see on the Draw-Tite Ball Mount w/ 2" Ball for 2" Hitches #DT49MR should be torqued to 250 ft. lbs. This shank come pre-torqued though, so you shouldn't have to worry about that. If there is…

I am happy to help you find a trailer tongue tool box for your Sure Trac trailer Andy. When you say you have 44 inches from the widest point, I believe you are referring to 44 inches up from the widest point of the A-frame towards the tailgate. You…