Filter by Style of Light
$12.33 - $12.33
Filter Results
Videos
for Trailer Lights
Help Articles
for Trailer Lights
Expert Answers
for Trailer Lights
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
view full answer...Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...Hey Melissa, thanks for reaching out! It looks like you have the Optronics Thinline lights on your Featherlite trailer so you'll need the following: Red - 2" #AL91RB - 4" #MCL75RB Amber - 2" #AL91AB - 4" #MCL65AB Which ones…
view full answer...Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…
view full answer...Hello Kurt, I can definitely help you out with the right clearance and side markers for your 6 x 12 dump trailer. I attached an image to reference for the lights/reflectors, these are the DOT requirements: - Rear reflector (#4 on diagram) 2 of the…
view full answer...The Dexter Trailer Idler Hub Assembly for 3,500-lb Axles item #84545UC1-EZ fits a item #L68149 bearing which has a 1.378" inner diameter. I would not recommend using this hub on a boat trailer. Instead, you'll want a galvanized one like item…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Jim, we do have replacement safety chain loops but since I don't know what Gooseneck hitch you have you'd have to choose one from the list below: - For B&W #BW1900-2-1600, - For Curt #C60691, - For Draw-Tite #58312, & For Reese…
view full answer...The light dimensions of the Optronics LED #TLL12RK are 7-9/16" long x 2-3/4" tall x 1-3/4" deep and the hole size needed is 6.75" by 2.5 inches. I confirmed this with my contact at the manufacturer and I've attached a template…
view full answer...Filters
1 results
