It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…
Typically 4-way wiring consists of 18 and 16 gauge wires. For a 4-way that has all 16 gauge wire you would want the Wesbar 4-Pole Flat Connector #W787264. The part #HM38138 uses 18 gauge for all wires but the white that uses 16 gauge.
A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
Trailer wiring generally uses 16 gauge wire, part #16-1-1. However, with a long trailer like yours you may want to go with a larger like 14 gauge #DW07550-1 or even 12 gauge #12-1-1. Each size is sold by the foot. You will need to have the lights at…
...have a 1-1/4 inch receiver and can be rated up to 3,500 lbs in GTW and up to 525 lbs in TW. Class III, on the other hand, have a 2 inch receiver and have up to 8,000 lbs GTW and 800 lbs TW. I will attach...
...The light dimensions of the Optronics LED # TLL12RK are 7-9/16" long x 2-3/4" tall x 1-3/4" deep and the hole size needed is 6.75" by 2.5 inches. I confirmed this with my contact at the manufacturer...
...similar lights that you could use as replacements.
I recommend checking out the Command LED lights # 328-K-51 for amber and # 328-K-52 for red. These measure 4" long x 1-1/2" tall and have mounting holes...
...wheels are 5 on 4-1/2. For the same bolt pattern on an etrailer hub and drum assembly you need the # AKHD-545-35-EZ-K. I'm sure you're also wondering about the price difference. The Dexter name generally...
Hey Kitti, I attached a couple help articles to this page that detail how to determine how much solar power you would need. There are a few factors so there isn't a set number we can give you at this time. Check out the links (down below) and if…
Thanks for the pictures of your lights! Based on that you'd want the part #328-003-19R for red lights that match what you have and #328-003-19A for amber. These ground through a white wire but you can run that white wire's ring terminal to…
Filter Results
(3)
