Videos
for Trailer Leaf Spring Suspension
Help Articles
for Trailer Leaf Spring Suspension
Expert Answers
for Trailer Leaf Spring Suspension
I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the…
view full answer...You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures…
view full answer...Thank you for providing the specs for the suspension components that you already have. Correct hanger spacing really depends on the components being used such as springs, hangers and equalizers. Most of the hanger spacing dimensions that we have…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...We have lift kits for trailer that easily add 2 inches to the height of the trailer. For that you'd want the…
view full answer...It looks like your MORryde ALLTREK 4000 Shock Absorbing Equalizers #MR89DR are longer than your previous equalizers were because your leaf springs are way too close to each other. The shackles should be creating more of a…
view full answer...Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal.…
view full answer...Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally…
view full answer...To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging…
view full answer...The AllTrek 4000 kits provide the best cushioning so if you were to upgrade from your CRE3000 kit to the Alltrek you would see a big improvement. If you have a 35 inch wheelbase…
view full answer...The hangers you currently have on your trailer are ones I have run into before. That being said, I spoke with MORryde and the #MR27ZR will still fit your trailer, but there is a modification that will need to be made. You’ll have to trim according…
view full answer...The torque requirements for leaf spring u-bolts depend on the diameter of the u-bolts that are being used. If the gross weight of your tandem axle trailer is 7,000 lbs, then you likely have two 3,500 lb axles. Typically 1/2 inch diameter u-bolts…
view full answer...