Trailer Jack - Hopkins

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

One way to determine the lift and jack height you need would be to measure the jack you currently have on your 2018 Intech Luna RV. If this is not possible, or you still aren't sure, you can also determine the correct jack using the coupler…

Hey Arthur; the Vesper Steel Modular Trailer Wheel #TA67RR has a standard 0.453" valve stem hole. The valve stem is included with the wheel. If you're planning to replace the valve stem with one that can handle a high psi rating you can use…

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

Hey Dallas, the distance from the mounting bracket of the Dexter Jack #DX72CR out to the furthest point out opposite on the pump enclosure measures 10.4 inches. Please enjoy my crude dimensional drawing and let me know if you have any other…

Hi Nick; the Dexter Self-Contained Hydraulic Jack #DX72CR can be bolted onto your dump trailer. The only other thing you will need is a 12V battery to power the jack. This has a lift capacity of 10,000 lbs, a support capacity of 12,000 lbs, and comes…

I have included a dimensional drawing of the Dutton-Lainson Round Swivel Jack #DL22335 that shows the overall extended height of the jack at 40-5/8" tall. This measurement is from the bottom of the wheel to the top of the jack when extended.

Hello Karl, thanks for reaching out. The Patriot Hitches Square Trailer Jack #PH66NR does not come with mounting bolts. You will need to source those locally.

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Hey Kellen, so the jack part #e83VV is considered the left side and the part #e23VV which is the right leg side. The difference is the side that the hydraulic fitting is on so that it better lines up. The left leg has the fitting on the right side…

Hey Brian, that specific mounting bracket has been discontinued but you can use the Black Molded ABS Mounting Bracket for Thin Line Series Clearance, Side Marker Lights #A65B in it's place. Let me know if there is anything else I can do for you…

We definitely have some trailer jacks you can use as a replacement for your Dutton-Lainson but it doesn't look like anything we have will work as a direct replacement. If you'd like to stick with the Dutton-Lainson brand then I recommend…