Trailer Jack - 22-1/4 Inch Lift

Hi David, Sure thing, I was able to get the dimension drawing showing the dimensions of the housing of the Self-Contained Hydraulic Jack #e33VV. As you can see, it sticks out 10.4" (about 10-7/16") from the back of the jack, 6" from…

The rule of thumb for estimating a tongue weight is 10-15 percent of trailer weight. A 4,600 pound trailer would have a tongue weight between 460 and 690 pounds. Somewhere between a 1,000 to 2,000 pound capacity jack would be fine. Having a jack that…

Hey Dallas, the distance from the mounting bracket of the Dexter Jack #DX72CR out to the furthest point out opposite on the pump enclosure measures 10.4 inches. Please enjoy my crude dimensional drawing and let me know if you have any other…

Hey Rod, The Ark Xtreme Off-Road Jack w/ 2 Wheels #ARK99FR has multiple slots in the outer tube of the jack that the mounting bracket can slot into. In the bottom slot you'd be right around 9-1/2" between the ground and frame with the wheels…

Hey Bill, thanks for getting in touch. The Dexter Self-Contained Hydraulic Jack #DX72CR is powered by the trailer battery. Dexter recommends a full size deep cycle RV/marine battery.

You could do either one! The etrailer Electric Trailer Jack item #e55ZV can be wired to the accessory circuit through your trailer's 7-way connector or you can connect it directly to your trailer's battery. The accessory circuit is typically…

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

You would choose a side wind or top wind jack based on several factors. Each has its advantages. If clearance is an issue for the radius of a top wind, then you would choose a side wind. The opposite is also true. It is my experience that a side…

Hello Josh, thanks for reaching out. The Self-Contained Hydraulic Jack #e33VV cannot be powered by the 7-way. It needs its own full size deep cycle RV/marine battery. You will also need battery cables for connecting to the HPU.

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Yes, in order to set your trailer up for use with shore power you will first need an AC distribution panel. For this, I recommend a Progressive Dynamics Series AC Distribution Panel. In order to bring power into the panel you will also need a power…

Hello Dave. To install the Dexter Self-Contained Hydraulic Jack #DX72CR you will need mounting hardware since that is not included. You will also need a 12v battery like the Bright Way Deep Cycle RV Or Marine Battery #BRW44FR to power the jack.