Trailer Door Parts - JR Products

Hey Jack, If you're talking about a transition plate then you'll want the etrailer Enclosed Trailer Transition Plate #e32JR. This can be installed on either end of the ramp to help make the transition onto easier or at the hinge of the ramp…

Hello Robert, Yes, the only difference between the 2 is that the etrailer Enclosed Trailer Transition Plate #e32JR is quantity: 1, and the #e99RV is quantity: 2. Right now it looks like if you wanted a better deal to buy 2 of the #e32JR. It is times…

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

Hey Mark, The 30 amp Portable Power Watchdog Surge Protector with Bluetooth, Wi-Fi, and Emergency Shut Down #HU42VR weighs 6 lbs and measures 19" including the cord, with the body measuring 12" tall; it is also 6.5" at its widest point…

Hello Mark, thanks for reaching out. When replacing leaf springs, it is important the new springs are identical in length to the old ones. There is a small amount of tolerance, like 1/2" or less, but any more than this can throw the suspension…

The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.

Hey Phillip. The Superwinch Terra Series ATV Winch item #SW1125230 definitely has the ability to do what you're wanting it to. It has a 50' rope and 2,500 lbs line pull. You are correct the 120v winches like item #DL25514 are going to run you…

All of our bumper strips are 96" long and have the holes pre-drilled out at 11" on center, but the nice thing is these can be cut and re-drilled to accommodate your application. You just need to choose which one has the width you're…

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when loading…

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

The trailer jack should very much NOT be powered by the breakaway battery. That was likely done by the previous owner for convenience. The breakaway battery is a dedicated battery for the breakaway system only. It needs to be able to apply the…

The holes in the Redline #D2-96 Pre-Drilled Round Rubber Bumpers are 11-1/2 inches on center. You can see the full dimensions by looking at the photo I've edited for you.

Hey Jack, If you're talking about a transition plate then you'll want the etrailer Enclosed Trailer Transition Plate #e32JR. This can be installed on either end of the ramp to help make the transition onto easier or at the hinge of the ramp…

Hello Robert, Yes, the only difference between the 2 is that the etrailer Enclosed Trailer Transition Plate #e32JR is quantity: 1, and the #e99RV is quantity: 2. Right now it looks like if you wanted a better deal to buy 2 of the #e32JR. It is times…

Yes, the H-Channel for Enclosed Trailer #36281-955 can be used for the side door frame on your enclosed trailer. It is specifically designed for building cabinets and doors on a trailer. There is also the 1/16" Thick Tube Trim for Enclosed…

Hey Mark, The 30 amp Portable Power Watchdog Surge Protector with Bluetooth, Wi-Fi, and Emergency Shut Down #HU42VR weighs 6 lbs and measures 19" including the cord, with the body measuring 12" tall; it is also 6.5" at its widest point…

Hello Mark, thanks for reaching out. When replacing leaf springs, it is important the new springs are identical in length to the old ones. There is a small amount of tolerance, like 1/2" or less, but any more than this can throw the suspension…

The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.

Hey Phillip. The Superwinch Terra Series ATV Winch item #SW1125230 definitely has the ability to do what you're wanting it to. It has a 50' rope and 2,500 lbs line pull. You are correct the 120v winches like item #DL25514 are going to run you…

All of our bumper strips are 96" long and have the holes pre-drilled out at 11" on center, but the nice thing is these can be cut and re-drilled to accommodate your application. You just need to choose which one has the width you're…

The etrailer Enclosed Trailer Transition Plate #e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when loading…

Yes, the Dexter Self-Contained Hydraulic Jack #DX72CR does come with a manual hand pump that can be used as a backup in the event of hydraulic malfunction.

The trailer jack should very much NOT be powered by the breakaway battery. That was likely done by the previous owner for convenience. The breakaway battery is a dedicated battery for the breakaway system only. It needs to be able to apply the…

The holes in the Redline #D2-96 Pre-Drilled Round Rubber Bumpers are 11-1/2 inches on center. You can see the full dimensions by looking at the photo I've edited for you.