Trailer Breakaway Kit

Hey Dwyane yes that is necessary unfortunately. We do have disc brake kits like the DeeMaxx Disc Brake Kit #DE68YR which will work with 7,000 lb axles that uses specific bearings. The last couple of things you'd need is a brake line kit…

I had one of the #C52042 push to test break away kits pulled from inventory, and found that the bolt pattern of the #C52042 measures 5-1/2 by 3-1/2 inches. I've linked though our in-stock systems and haven't found a push to test break away…

Hello Bob, I’m sorry, but we do not offer kits with 5/8" studs. That said, the Hydrastar actuator paired with the Kodiak brakes is a great setup! The only thing I would recommend changing is the brake lines, here’s the combination I would…

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Hello Mike. It sounds like you are wanting to add electric brakes to your boat trailer that currently has no brakes. This is possible, but you will first need to make sure that your axle is equipped with a brake flange at the base of the spindle. The…

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

Hey Patrick, those dimensions don't appear to be anywhere from what I can find. While I can't give you that info, I can say that as long as the bearings fit, and you have a #11 or #12 spindle, then the Dexter Trailer Hub and Drum Assembly…

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

Great question, William! The Karrier ST225/75R15 #KE63KV is a KR35 while the Karrier ST225/75R15 #AM10303 is a KR03 according to Kenda. There is a slight variation in the tread pattern and from what Kenda says about them it looks like the KR03 is…

Hey Eddie, thanks for the pictures. From seeing that I can tell you have a 3,500 lb axle and the correct replacement hub would be the part #AKIHUB-545-35-G-EZ-K that you referenced which comes with new bearings and seal.

The lid of the Bright Way Trailer Breakaway ICU Kit with 12V, 5-Amp-Hour Battery, Charger, and Wire Loom #BW94FR that you referenced has a wiring diagram shown that details how it wires. Not seen is there is a single wire that runs up to running…

Hey Nick, since the 7-way blade is a lot more popular than the 7-way round I would definitely recommend going with a 7-way flat. For that we have the part #e99011 which comes with a junction box to make installing on your trailer as easy as possible.…