Trailer Brakes - 12-1/4 x 5 Inch Drum

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

...I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below. eTrailer Electric Trailer Brake Kit part...

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

Hello Darren. Thanks for reaching out, I can definitely help with this. To convert your 2024 Brinkley Z2900 5th wheel over to disc brakes, you will need a disc brake kit, a brake line kit, and electric over hydraulic actuator, and a breakaway kit for…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

Hey Mark, since we know your trailer has two 7k axles and a bolt pattern of 8 on 6-1/2 inch the correct DeeMax disc brake kit would be the part #DE66AR which comes with everything needed to add electric over hydraulic DeeMax brakes to your trailer.

Hey Dwyane yes that is necessary unfortunately. We do have disc brake kits like the DeeMaxx Disc Brake Kit #DE68YR which will work with 7,000 lb axles that uses specific bearings. The last couple of things you'd need is a brake line kit…

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

Hey Darrel, since you like the DeeMax 7k slip on kit the part number you'd need is the #DE46AR which comes with the slip on rotors and the needed actuator and lines. So for an idler hub what you'd want is the part #8-231-50UC1 and you'd…

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…