...Where does the measurement come from to determine if I have 2-1/4 or 2-1/2inch brakes? I need to replace the brakes on a Road King boat trailer with 3700# axles. It seems the wheel cylinder is blown...
Hey Alan, we actually have a kit for exactly what you are looking for with the part #HYD44VR. This kit was designed for converting a trailer with tandem 5.2k axles to electric over hydraulic disc and comes with everything needed so it's a one…
...I currently have three diffrent self-adjusting assemblies for your boat trailer with 10" x 2-1/4" electric drum brakes which are attached for you below.
eTrailer Electric Trailer Brake Kit part...
Hey Dwyane yes that is necessary unfortunately. We do have disc brake kits like the DeeMaxx Disc Brake Kit #DE68YR which will work with 7,000 lb axles that uses specific bearings. The last couple of things you'd need is a brake line kit…
In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…
Hey Jeff, thanks for reaching out! What you're looking for is the Hydrastar Disc Brake Kit w/ Actuator for Tandem Axle Trailers #HYD44VR. This comes with the rotors, calipers, brake lines, ad an electric over hydraulic (EOH) actuator so…
First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…
It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…
I sure can Bob and thanks for the information! Since you have a Lippert 3,500 lbs axle you'll be able to use the Easy Grease Trailer Hub and Drum Assembly for 3.5K Axles item #AKHD-545-35-EZ-K, you were looking at. These have a 5 on 4-1/2 lug nut…
Hey Mark, since we know your trailer has two 7k axles and a bolt pattern of 8 on 6-1/2 inch the correct DeeMax disc brake kit would be the part #DE66AR which comes with everything needed to add electric over hydraulic DeeMax brakes to your trailer.
There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…
Very easy process, good prices and my products were shipped on time and were delivered on time. The instructional videos online helped make installation easy!
Filter Results
(2)
