1. Home
2. Trailer Parts
3. Trailer Couplers
4. Straight Tongue Trailer Coupler
5. Titanx

First you will need to remove the old hydraulic equipment. Remove the surge coupler or actuator, remove all the lines, and finally remove the brake assemblies. If you have 10 inch diameter hub and drums, you may need to replace those as well. If you…

Hey Neal, that is an interesting question. There is no specific angle I can give you since this is not something we have ever tested to see. Generally, normal on-road driving conditions will not be severe enough angles to cause the coupler to bind.…

Hello Casey, thanks for reaching out. It sounds like the 2,200 lb Timbren Axle-Less Trailer Suspension #ASR1THDS03 will be sufficient for your build. Even if the GVWR is 1,500 lbs and your water tank is full, you would still be safely under 2,200…

Hey Carl! How much does the Weigh Safe weigh? With all of the parts put together the #WS88RR weighs 35-1/2 lbs. If you need anything else don't hesitate to reach out in the comments below.

The only difference in the Demco Channel Tongue Trailer Couplers #DM16080-95 and #DM15931-95 is going to be the bolt pattern. One will have the 5-Bolt hole pattern and the other is going to have 4-Bolt holes. I have included images below showing the…

To mount the Channel Tongue Trailer Coupler - Trigger Latch - Bolt On #CT-5003-Z, I recommend using 1/2 inch bolts. The higher the grade, the stronger the bolt. I've attached the review video to help as you plan this installation.

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

...of the channel of this unit? I see the other 21k lb option is from Titan and there is measurement of 3.75 ID channel height. Also what is the from the 5/8 mounting holes to the center of hitch ball...

Hey David welcome back! I would mount the rubber hoses on the side of the frame, for the Kodiak Hydraulic Brake Line Kit item #20TA-BLKIT. To attach the line holders, I recommend the Self-Tapping Screw - 1/4" -14 x 3/4" Long - Zinc item…

The only difference between the Demco Channel Tongue Trailer Coupler part #12564 and Demco Channel Tongue Trailer Coupler part #DM12717 is the bolt pattern which is just slightly different with one having an extra hole.

Hi Kyle; we do have an adapter like the one you're describing. What you can use is the Curt 4-Way Flat Magnetic Connector Adapter #C34RJ. The 4-way on your vehicle and trailer plug into the magnetic quick-snap connection for a quick and easy…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…