Videos
for RV Sewer Hose Fittings
Help Articles
for RV Sewer Hose Fittings
Expert Answers
for RV Sewer Hose Fittings
Hey Wyatt, so we have a hose that was designed to be used with the #T01-0091VP with the part #W01-4180 which does have a different thread size. This is intentional so that someone doesn't use a standard garden hose that someone might attempt…
view full answer...Hey Gene, we don't have that exact one you're looking for but we do have the Vitrifrigo C85i RV Mini Fridge with Built-In Freezer #VT34FR which is 3.2 cubic feet, runs off of 12V power, and does include a built in freezer.
view full answer...When RV sewer pipes are attached they use a solvent like the #A05-0303 that permanently attaches the two pieces. There isn't a way to separate them and only option is to cut off the old section and glue on a new part.
view full answer...The P-15 model information you provided for your Dexter axle does indicate its model, but you will still need to note its length and capacity before locating the correct replacement. If you are able to find a longer serial number somewhere on the…
view full answer...Thanks for the photo and that model of Happijac is nearing a quarter-century old as of this writing and there are no longer replacement parts available for it. The best option we can offer are new camper jacks, the Brophy Cable Camper Jacks and you…
view full answer...You're right, a picture of the flange-to-flange width is definitely a good idea, so I contacted the manufacturer, Valterra, to get the dimension, and then went ahead and made a photo for you of the Valterra elbow you asked about: - RV Sewer Elbow…
view full answer...The standard Valterra replacement valves like the part #T1003PBC are designed to attach to a remote handle that's further away while the Valterra Bladex like part #T1003VP the handle is right at the valve instead. Both valves are interchangeable…
view full answer...For your replacement Dexter hydraulic brake assemblies, you will want the Dexter Hydraulic Trailer Brake Kit - Uni-Servo - 10" - Left and Right Hand Assemblies #23-312-313. These will work very well with your existing hub/drum assemblies.
view full answer...Since the bolt holes line up vertically and horizontally you'll be able to bolt the Trailair Air Ride 5th Wheel King Pin - Leland 7920 #UF35-946208. This specific pin box actually has an 18" king pin to first set of bolt holes measurement…
view full answer...When installing the #34466NDHR19AAA you can use a nipple like #T3524 and connect it to your the waste valve with some ABS cement #A05-0303 and then a #F02-2103 coupler onto the tank pipe.
view full answer...The waste valve you came from, part #T58 is not a valve that uses glue because it is designed to attach to the RV side and the waste tube with the bayonet adapters on each side of the valve. We do have waste valves that do require gluing. I have…
view full answer...That is correct. There is nothing to support the bumper when you install the Curt Hitch item #C15398 on a 2013 Toyota Tundra. That hitch was designed for the trucks without the factory hitch so there's no reason for it to have built in support…
view full answer...