RV Fresh Water - JR Products

Hello Blake, thanks for reaching out. I did some digging and I was able to find a reference for the 92655 hub. This uses the 15123 inner bearing and 25580 outer bearing. It will be a 12" drum as well. This reference didn't tell me the bolt…

Hey Korey, That's a totally normal installation for the RV Holding Tank Heater #372HTH-A. My only word of advice would be to run a dedicated outlet for it to plug into with a switch somewhere in-line that's easy to access so you can cut power…

I looked up the dimensions of your High Pointe EC942K9E and it's 15 inches deep, 15.7 inches tall, and 29.9 inches wide so the Furrion Over the Range RV Convection Microwave #FMCM15SS that you referenced would easily fit in place of it and would…

The Flair It PEXLock Elbow Fitting part #FL44ZR that you referenced is a 1/2 inch FPT fitting. If this is the type of fitting you were looking for it would work great. Let me know though if you were thinking about something else.

Hey Bill, the Flair-It High Pressure Hose #FL24FR that you referenced can be used with hot and cold water.

The ThermaHeat RV Dump Valve Pipe and Elbow Heating Pad #277-000162 pulls 0.3 amps and the ThermaHeat RV Holding Tank or Step Heater Pad #277-000164 pulls 4.8 amps. Assuming that you're having them all run off the same switch and wiring you would…

The Therma Heat heating pads #277-000164 are thermostat controlled, automatically coming on at 45 degrees Fahrenheit and off at 67 degrees Fahrenheit.

Hey Scott! I've got an axle I think will work for you but I am concerned about your measurement. Our axle's are categorized by hub-face-to-hub-face and spring-center-to-spring-center measurements as shown in the diagram below. We do not go by…

Hey Scott! Yes, the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat item #277-000164 will turn on at temps lower than 45 degrees. It has been tested and will work with temperatures as low as -32 degrees. I have linked an installation…

Hey Raymond, the Flait-It High Pressure Hose #FL24FR is made of Nylon 11 which is extremely easy to bend, but it does have an 800 PSI rating so it will work great with a pressure washer. Most pressure washer hoses are going to be made from either…

Hello Dan, thanks for reaching out. You asked a good question so I went out to our warehouse and got my hands on the B&B RV Fresh Water Fill Diverter Valve and Plate Assembly #BM35RR. The threaded fittings are not bonded together, and I was…

When this has come up before, ThermaHeat recommends removing a portion (18-1/4 x 12 in this instance) of the insulation on the tank large enough to install the #277-000164 heater so it's in direct contact with the tank. You're correct,…