1. Trailer Parts
2. Padlocks

I spoke with B&W about the B&W Companion OEM 5th Wheel Hitch like part #BWRVK3600 and they recommend using the Master Lock 1-9/16" Wide Solid Brass Body Padlock with 2" Shackle part #ML140DLH to lock…

Hello David. All of the 2-1/4" or 2-1/2" long 9/16" wheel studs we offer have a knurl diameter of .68, such at the Kodiak Wheel Bolt #K916WB25. We do not have anything with a knurl size of .60 or .62. We do have…

Hello Pat. The Replacement Trailer Hub Wheel Stud #RG03-080 has a .545" knurl diameter. The distance from the cap to the threads is 1-3/16".

We don't have an option that will allow for all of them to be keyed alike but I can get you down to one key for the hasp locks and another for the coupler lock. The Trimax Puck Locks for Trailer Door Hasps #TMX73FR comes with three…

Yes, all of the locks and keys in the Trimax Stainless Steel Padlocks with 3/8" Shielded Shackle Set #TMX48ZR are keyed alike so you don't have to keep track of all that!

The Trimax Puck Lock for Trailer Door Hasps #TMX96RR cannot be keyed alike. While disappointing I'm sure, there is another option to consider, which is to order a quantity of two of the Trimax Puck Locks for Trailer Door Hasps #TMX73FR. The…

Thanks for reaching out, Mark! The Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 10,000 lbs #TJSCHD-24-4 are designed with 11 Gauge steel and install using 1/4" self-tapping screws like the Self-Tapping Screw #FA1131822. Then…

I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Gary, so the Yakima 54" Tracks for Roof Racks #Y26RR that you referenced are compatible with your setup as they provide the standard dimension roof tracks that your Sherpa Crows Nest was designed to fit. With that said the correct…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular…