Lubricants Sealants Adhesives - Performance Tool

...of grease. You will probably use 3/4 to a full tube for each wheel. You will need the Performance Tools Heavy Duty Grease Gun - Lever Action - Aluminum item # PTW54290 to pump the grease into your axle. I...

You are going to want either our Bearing Kit #BK2-100 or the Timken Kit #TMK52VR. Both of these kits will give you the inner/outer bearings and races along with a grease seal and cotter pin/D-washer for one hub. You always want to replace the race…

We recommended to repack the wheel bearings on your trailer every 12 months or 12,000 miles. There is not a specific guideline as far as actually replacing the bearings. When repacking them with grease, you will also just want to check for any damage…

Hello Daniel, Great question! The information that I am finding on 5957430 six lug S/N 121180384 is that it is a 5,200 pound axle. You will want the Bearing Kit #BK3-300. This kit is going to come with outer bearing LM67048, inner bearing 25580, your…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Hey Dan, The info you provided does tell us a bit about the axle but isn't enough to look up what components go with with it. With it being a 3,500lb axle it's probably a generic 3,500lb kit for the bearings and seals but I'd hate to not…

Hi Tony; the #BK2-100 and #TMK52VR come with the same size bearings and grease seal. The main difference is the Timken name. This is usually associated with a higher quality bearings that are made in the USA which also accounts for the higher cost.

Hey Roland, thanks for reaching out! Overslung axles are a special order situation and we unfortunately only have standard axles here at etrailer. With that being said, you can order a standard axle that meets your specs and then use the Dexter…

You are correct that in the Blue Ox SwayPro Owner's Manual they do recommend use molybdenum grease on both the hitch ball and the spring bars. The LubriMatic Moly EP Grease #LM54FR in a grease gun, such as #L30480, will work well. You could use…

The spindle on your Dexter axle is going to be similar to the #84 E-Z Lube Spindle #TRU74FR in the image below. You can see there is a hole in the spindle where the grease will push through into your inner bearing. From there it will move along the…

I recommend using the LubriMatic LMX Industrial Strength Grease #L11390 on the Wet Bolts #LC52SV for the Road Armor Shock Absorbing Equalizer Kit #LC696740. This grease is formulated for superior performance in cold and hot climates. It is also…

You can check the condition of your hub's races by carefully removing all bearing grease with a rag to expose the actual surface of the races. When they are completely free of grease, etc., inspect them for any signs of scoring (very slight…