Filter Products
Filter by Accessory Style
$19.29 - $76.19
Videos
for Horse Trailer Accessories
Help Articles
for Horse Trailer Accessories
Expert Answers
for Horse Trailer Accessories
Are the holes you are referring to threaded? If so then you could drill a 1/4" hole into one of our pads (see below) and then use a bolt to attach them to the wall. If the holes are not threaded then it may just be best to use a few…
view full answer...We do have a selection of rubber mats that you can add to your gooseneck trailer which I have linked for you to filter through. The thickest rubber mat that we currently have to offer is the Ribbed Rubber Trailer Mat #4872SM. This mat measures…
view full answer...A 3/8" self tapping screw seems a bit large for the Horse Trailer Side Pads #HTP1260BK but I do recommend always using a washer like the 3/8" #01292006-020-01. This will help spread out the surface area which means the pad is less…
view full answer...The PS-8 screws should work very well going into either material you mentioned. The threads are coarse enough that they'll get good hold on the aluminum or the rubber. For best results, you'll want to ensure that as many screws as…
view full answer...I suggest the Advent Air RV Air Conditioner w/ Air Distribution Box and Start Capacitor, #ACM135C. This is a 13,500 Btu ductless air conditioner that has a distribution box with built-in thermostat to control the fan and temperature and a start…
view full answer...For the installation of your 60-inch horse trailer side pads, I recommend using the Trailer Horse Pad Screw #PS-8. The pads are installed in the trailer directly via the screws and can be mounted wherever is convenient. I have included a photo from…
view full answer...If your current hubs use grease and are not oil bath then you will need idler hub #008-399-92 to go with slip-on rotor #K71-635-2. But if it is an oil bath set up you will need #008-399-93. In either case the hubs have the 8 on 6-1/2 bolt circle, 5/8…
view full answer...The only thing I found on your Dexter 70-7 is the Replacement 13" Rotor for Dexter Disc Brakes #K71-631-00 which has 70-7 stamped on it. The #K71-631-00 fits 8,000 lb. Dexter disc brake kits like the #K71-646-2, #K71-646-2-91 or #K71-646-2-90.
view full answer...We have the Dexter Trailer Hub part #008-399-92 which is an 8k hub with 5/8 inch diameter wheel studs.
view full answer...The RoadActive Suspension Custom Leaf Spring Enhancement Kit part #RAS54FR is an excellent dual purpose system for a 2017 Chevrolet Silverado 1500. It works to not only reduce sag/squat while towing but also helps with body roll and sway. This system…
view full answer...Hey Eric, thanks for reaching out! Yes, a license plate with mounting holes 5-3/4" apart will work with the Optronics LED Trailer License Plate Light with Bracket #LPL56CB just fine.
view full answer...I must recommend that you replace the hub/drum as well when changing the size of your braking assemblies because the surface area on the old drums may not line up with the new braking assemblies which is why I recommend replacing both at the same…
view full answer...