Filter by Hitch Fabrication Part
$27.21 - $134.96
Videos
for Hitch Fabrication Parts
Help Articles
for Hitch Fabrication Parts
Expert Answers
for Hitch Fabrication Parts
I think the best option we have for you is a universal weld-on hitch plate like one of the following that I have attached for you. We do not really have any direct fit hitch plates for you so I think this will be the best option we can offer. If you…
view full answer...When it comes to square tubing, there is always going to be a degree of tolerance even with the most precision manufacturing. The tolerance of the Curt trailer hitch receivers such as the Curt Trailer Hitch Receiver part #C15409 is around .050"…
view full answer...I would be happy to and thanks for the pictures! The B&W Heavy-Duty Trailer Hitch item #BWHDRH25122 measures 5.4" from the top of the frame brackets to the top of the receiver and 19-1/2" to the back of the receiver from the last bolt.…
view full answer...Hey Seth, yes we do have a hub/drum that fits the etrailer 7k axle part #e95GR with a 6 on 5-1/2 inch bolt pattern with the part #AKHD-655-6-EZ-K.
view full answer...I'm not 100% sure which locking hitch pin you have but it sounds like a complete failure of the mechanism. This doesn't happen very often but it is possible. I would try spraying some WD-40 up into the lock if you can where it meets the hitch…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Each of the motors of the Happijac Electric Truck Camper Jack System #LC736515-ELKIT is protected with a 25 amp fuse. So it can pull right up to 25 amps.
view full answer...Hi Cody; Buyers Products was unable to confirm if the #3371809060A could fit your 1990 Ford F-Superduty. What you can do is look at the measurements below to see if they line up with what you have. If not, you could use one of the following universal…
view full answer...Though we do not have a custom fit option for your two Freightliner trucks, I may still have something that will work. I will say that both of these will depend on how wide the frame is where these would attach. The more heavy duty option will be the…
view full answer...According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…
view full answer...Hey Jack, If you're talking about a transition plate then you'll want the etrailer Enclosed Trailer Transition Plate #e32JR. This can be installed on either end of the ramp to help make the transition onto easier or at the hinge of the ramp…
view full answer...For the Curt winch mount, #C31010, or any of the similar mounts, you will need to compare the mounting pattern on the mount to what your winch requires. I have included 2 pictures. One shows the mount pattern of the Curt mount.
view full answer...Filter Products