Heaters - Catalytic Heater

Hey Scott! Yes, the ThermaHeat RV Holding Tank or Step Heater Pad w/ Thermostat item #277-000164 will turn on at temps lower than 45 degrees. It has been tested and will work with temperatures as low as -32 degrees. I have linked an installation…

The Brophy Camper Scissor Steps for truck campers, #AS04, are intended for an entry height of 31" to 40". If your camper door sets within that 31-40' range then yes this will fit your rig. Please see attached image for measuring points…

The best replacement water heater for your Atwood GC6AA-10E is the Dometic RV Water Heater #DMC74FR which needs a cutout of 12-3/4" tall x 12-3/4" wide x 19-7/8" deep to fit. Then you just need a door like the 12-3/4" #DMC58FR to…

I reached out to JR Products and the RV Holding Tank Heater #372HTH-A will turn off when the area reaches 39 degrees Fahrenheit. So it will only heat the tank when the temperature drops below 34 degrees and will shut off once the temperature reaches…

I spoke with my contact at CE Smith and the wood in the Carpeted Bunk Boards #CE27840 is a non-treated wood. The carpet though is marine grade carpeting. Typically bunk carpet will last a few years, but that really depends on how often its used.…

The Brophy Scissor Step Bracket #TSSB will install on the edge of your tailgate. You will have to drill two holes for the L shaped pins. After drilling, all you have to do is simply insert the L pins into those holes and attach you Brophy steps! For…

I checked with Progressive Dynamics and the approved breakers for use with the Progressive Dynamics 4000 Series #PD4045KA are: Thomas & Betts – TB & TBBD series Square D – HOM & HOMT series Cutler Hammer/Bryant – BR & BRD series GE –…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The Camco RV Heating Wall Thermostat #CAM09231 you reference, is accurate to the set temperature + or - 5 degrees, and has a temperature range of 50°F to 90°F.

For a 3,000 watt inverter you'll need a 300 amp hour lithium battery like the Go Power Sun Cycle Advanced Lithium RV Battery item #GP26QR.

Heater #PTW5009 draws 13 amps at 12 volts which equals out to about 156 watts. I did a little research and from what I could find it is not ceramic.

For DC electricity, I can help you out. You can run a 10 gauge wire like #10-1-1 sold by the foot from a 6-way or 7-way connection from the 12V to a deep cycle 12V battery and then run the battery to a ground on the trailer. You can use a solenoid…