Filter Results
$1,332.16 - $1,350.58
$1,332.16 - $1,350.58
Videos
for Generators
Help Articles
for Generators
Expert Answers
for Generators
The Pace Edwards Switchblade part #PE63CV does have a two year warranty. At one point it was shorter but we just hadn't updated the description on our product page.
view full answer...Entry door locks, like the Bauer Products #BA64FR, typically will have a sticker on the inner handle portion that sits inside your RV, but I have installed a few where they also have the key code on a sticker on the inner components of the handle.…
view full answer...Yes, the Champion 4,500-Watt Dual Fuel Portable Inverter #CH44FR does come with a battery.
view full answer...The Draw-Tite Front Mount Trailer Hitch Receiver #65076 will fit your 2023 Ford F-350 dually. It features a bolt-on installation and has a 2" receiver. The hitch has a 9,000 lb line pull, 500 lb vertical load, and 5,000 lb gross trailer…
view full answer...Yes, the Voyager WiSight 2.0 Wireless RV Backup Camera #ASA84YR will have consistent signal with your setup. The camera and monitor both have a wireless range of 60 feet or more. So even with about 52' between them, you will be well within…
view full answer...Yes, there is a front mounted hitch for your 2022 Ford F-350 dually with a diesel engine. It is the EcoHitch Hidden Front Mount Trailer Hitch Receiver item #EH83GR. This hitch is custom fit and bolts to your Ford with included hardware. This front…
view full answer...Jameson's wording could've been better but what he meant was that there isn't any way to adjust the connection point of the Curt CrossWing Lightweight #C92DR since it only allows for you to raise of lower the hitch head. In…
view full answer...We can certainly point you in the right direction, although I do not have a way to look up exactly what model converter/charger you currently have in your 2017 Winnebago Micro Minnie. If you can provide the brand and model number of your current…
view full answer...The correct height setting is going to vary by trailer but you can get there taking some measurements. First make sure your trailer is on level ground and then measure from the ground up to the bottom of the king pin. Then on your truck take a…
view full answer...The Curt T-Connector #C56332 that you referenced actually doesn't carry the brake controller signal. It tees into your vehicle wiring and only carries the basic trailer lighting functions. If you are trying to tie in a Tekonsha brake…
view full answer...The slight gap you see is normal. The drum is not supposed to make contact with the brake mounting plate. There are some instances when mixing brands of brakes, hubs, and axles, that won't line up properly but in this case it is normal. I…
view full answer...That's quite a large gap between the top plate of the hitch and the pin box surface. That to to me would indicate there's a problem. Most likely it's a high pinned king pin. I would disconnect, try lowering the trailer using…
view full answer...