Filter Results
$9.40 - $9.40
$9.40 - $9.40
Videos
for Camping Tools
Help Articles
for Camping Tools
Expert Answers
for Camping Tools
We do have a trailer hitch receiver that fits your 2024 Nissan Pathfinder, from Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C46DR
view full answer...If you are unsure if you have the tow package or not, the only way to find out for sure would be to contact a dealership with your VIN. With certain vehicles we can sometimes check to see if certain electrical components are present, like a 7-way…
view full answer...Yes, we can ship the Space Dock 2" Receiver Adapter for Torklift Palomino Landing Pad Bumper part #TLA7900 to you in Canada! However, the quoted shipping costs does not include all brokerage fees and duties. Taxes are not…
view full answer...No, the Replacement Prop Rod Assembly for Leer Tonneau Covers #LE54MR is not the correct fit for a Leer HF350M tonneau cover. We currently have 3 replacement prop rods for Leer HF350M tonneau covers. - Replacement Prop Rod Assembly for Leer…
view full answer...We always recommend to stick with what the owner's manual says for your car so if the manual for your 2019 Subaru Outback Wagon says to only install tire chains on the front tires then we also recommend only installing the Konig…
view full answer...While we have trailer hitch for a 2022 Nissan Pathfinder, a hitch from a Murano won't fit because of the different frame sizes and bolt hole locations. For your '22 Pathfinder, the correct hitch fit is the…
view full answer...The closest modern tire size to a 7.00-15 tire is a 225-75-15 like the #AM10256 tire you mentioned. Typically, a 225/75-15 tire will measure about 8-3/4 to 9 inches wide by around 28-1/2 inches in diameter. We offer the same size in a Load Range E…
view full answer...Yes. You can mount an awning on Yakima Overhaul HD systems like the #Y01151-5855. If you wanted to use the Yakima Slim Shady Awning #Y36VR, that awning will mount using the included clamps to the HD bars on the Overhaul system. If…
view full answer...One of two things are going, but most likely you installed your driver gear backwards. Since it is a driver gear there should be a drive shaft on both sides of the jack (one for the handle and one for the follower leg). If you installed it…
view full answer...I measured the mounting bracket on the Rhino-Rack Shovel Holder #RR43218 to get you the hole spacing dimension you need. The center-to-center spacing between the two mounting screws is 1-3/8-inches. The width of the bracket is 2-3/8-inches. Both…
view full answer...I recommend that you first remove the current lock and identify the cutout measurement. I have two optons listed below and which one you need is based on your cutout dimensions. Be aware that entry door locks are not a tight tolerance fit, so the…
view full answer...The only difference between the 1/2 Inch Lug Nut, #12CLN and #12CLN-L is the length of each. Both are bulge style which means they have a 60 degree tapered end. The inside depth of 12CLN is 1-1/4 inches. The inside depth of 12CLN-L is 1-3/4 inches.
view full answer...