Videos
for Bimini Top Parts
Help Articles
for Bimini Top Parts
Expert Answers
for Bimini Top Parts
If you're looking for a new coupler to replace a Tie Down Engineering Model 20, I recommend the Demco Hydraulic Brake Actuator part #DM8204311 which like the Model 20 has a 20,000 lb weight capacity designed for a 2-5/16" hitch ball.…
view full answer...I do not recommend going with 4,000 lb leaf springs on your boat trailer with a GVWR a touch less than 3,000 lbs. It will make the ride bouncier than need be, but a 3,500 lb spring should do well, assuming when your boat is on the capacity is…
view full answer...I recommend using the Draw-Tite Max-Frame Trailer Hitch Receiver #76184 on your 2023 Chevrolet Traverse. This receiver is designed to install behind your rear fascia and is accessible by the removable panel on the rear fascia. It has a welded tab…
view full answer...The Curt Trailer Hitch Receiver - Custom Fit part #CU94FR for the 2020 Chevy Traverse does not require drilling. However, it requires temporary removal of bumper/fascia during installation. The exhaust must be temporarily lowered for installation,…
view full answer...I recommend the Curt Class III Max Frame Receiver Hitch part #CU29FR for the 2020 Chevrolet Traverse because of its concealed cross tube design it provides the best ground clearance compared to the other options. The concealed cross tube design sits…
view full answer...According to Air Lift, there are a few things that can cause this issue. The problem is likely an air leak between the manifold and the compressor or simply a weak compressor that would need to be replaced. To get the compressor running again so you…
view full answer...The difference between a load range E and load range F tire of the same size, 235/85-16, is the weight capacity and pressure. The Karrier Radial Tire, Load Range E, #AM10295, has a capacity of 3,640 pounds at 95 psi. The Load Range F Tire, #AM10501,…
view full answer...For a 48 inch Bad Boy Zero Turn the correct grass catcher is the part #RCMMS4-EXS1.
view full answer...Yes, the Taylor Made Bimini Top Deck Hinges for Boat Sidewalls #3695854 (chrome) will work with the Replacement Nylon Sliders for Taylor Made Bimini Top Slide Assemblies #3691205. If you are wanting stainless steel, you would want the Taylor Made…
view full answer...I checked with Rack Em and for your BadBoy MZ Magnum you'd want the part #RCMMS4-EXS1.
view full answer...I went out to our warehouse and measured the Single-Speed Boat Trailer Winch part #315-W2000D for you. The dimensions of the base are as follows; 6-1/4" long x 3-3/4" wide.
view full answer...I can help you determine the right replacement double-eye leaf springs for your Keystone Hideout, though we don't have any way of knowing what specific ones you need. It's pretty easy though, as all you need to do is measure your current leaf…
view full answer...