Bilge Pumps - Submersible Pump

Unless you want to completely clean out every bit of grease you will need to stick to a LMX red grease like item #L11390 that comes with the CE Smith Trailer Idler Hub Assembly item #CE13515. You can use your blue marine grease but you can't mix…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

To determine which hubs would be best for your boat trailer there are a few things you will need to look at; the axle capacity on your boat trailer, the inner bearing number, outer bearing number, grease seal number, the bolt pattern of your wheels,…

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

The hub/drum you sent in a picture of is a Lippert 8,000 lb axle hub with an 8 on 6-1/2 inch bolt pattern designed for oil-bath applications. The correct replacement then is the #8-285-10UC3-A.

The replacement hub/drum you would need is the part #8-219-50UC3. Because you gave me the grease seal number I was able to determine that there is only one Lippert spindle size that has the 10-36 seal. The #8-219-50UC3 also has the same bolt pattern…

The Trailer Hub and Drum Assembly - 8,000-lb Axles - 8 on 6-1/2 - Oil Bath #8-285-10UC3-A is the replacement option we have. The only difference is the wheel studs are 5/8 inches instead or the 9/16 inch wheel studs of your current hub. This comes…

There could be a number of causes as to why your Everchill RV Refrigerator w/ Freezer #324-000119 is malfunctioning. I would start by removing the fuse to fully cut the power and waiting a few minutes for the unit to fully reset. If resetting the…

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

It sounds like the Halogen lights you are using are pulling too much power causing you to blow the breaker once they heat up. I recommend changing them to LED's like the LED Pontoon and Fishing Boat Docking Lights item #TN23ZR.

Hey, thanks. You're not so bad yourself! Going to a larger tire size is possible but there are a few things to think about. Chief among these things is clearance. When going from an 8 inch tire to a 12 inch tire the diameter will increase by 4.4…

My recommended first step for you to take is to determine what tire size you would need. If you check the plate on the trailer frame near the coupler there will the VIN, axle capacities, as well as the trailer tire size and Load Range recommended.…