2000 Chevrolet C/K Series Pickup Bug Shield

For the Edge CS2 Evolution Diesel Tuner you will need to enter the programming menu. You will turn on your vehicle without starting it. Then use the Menu button to open the main menu and scroll down with the arrow to the Programming on the screen.…

The Leer Soft Tonneau Cover #LE38VR is a great option for your 2024 GMC Sierra 2500 with the 6-3/4' bed, but since you're wanting to use a ladder rack as well we need to look at a different solution as the clamping system and the…

The manual switch for the Pace Edwards Bedlocker Retractable Hard Tonneau Cover #PE44CV can be found as part #311-BL-1120 on our site. This plugs into the harness at the canister and then you route and install the switch wherever it works best for…

Hey Bill, yes the Draw Tite hitch part #DT65GR does come with all of the needed install hardware for the hitch including the fishwire bolt leaders.

We've checked in the past and have been told the only current landing gear motor that can be used with your Atwood setup is the part #LG-142178 which even having a lower capacity will still do a great job. The jack motor doesn't…

Currently SuperSprings only offers the rear SuperCoils for your 2019 Ram 1500 2wd. They are available in either a 2,058lb #SSC-50 or 2,480lb #SSC-51 coil capacity. If you plan on keeping the camper on your Ram then go with the higher capacity…

The Replacement Lockable Knob for Thule Spare Me Spare Tire Bike Rack #TH93NW has a 3-7/16" long bolt that has a 3/8" diameter and 24 threads per inch (fine thread).

We do have a trailer hitch receiver that fits your 2024 Nissan Pathfinder, from Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C46DR

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The Edge Diesel Evolution CTS3 Performance Tuner #EP96TR referenced in your question is confirmed to fit your 2002 Ford F-250 7.3L Diesel. I can't be certain what your local shop is referring to with regards to an existing chip on your truck but…

That means the programmer you have was installed on a different vehicle and wasn't returned back to stock before you got it. These can only be programmed to one vehicle at a time, so you'd have to track down the original vehicle the…

Since you said you couldn't find a power level option on the Edge programmer you have on your 2008 Ford F-250 there is a great chance you actually have an Insight Monitor like part #EP84030. This product only allows you to look at various engine…