Most Popular Aluminum Shank - Silver for Nissan Pathfinder

Very strong, easy to install and very secure. Yes a bit pricey, but well worth the money. I did notice there was what I thought was an unusual amount of play in the receiver. I called etrailer and Marcia was so very helpful and very concerned that I may have received the wrong product. She even called the manufacturer and found out what the changes that were made by the manufacturer which made the pictures incorrect. My hat is off to Marcia and all the folks at etrailer

Click to Enlarge

ball mount fits loosely in the receiver so that the pins that extend out from the ball mount shaft through the holes in the receiver don't extend out far enough, for my liking. This is because since the ball mount shaft has so much play, it will shift to one side. Then, the pin on the other side does not extend all the way out of the hole so that it is not flush. True, i am being paranoid. However, i imagine a case like a crash where enough force could pull the shaft out from the not fully extended pin side to release the trailer to wreak more damage. I would just feel more secure if the pins went out further through the receiver or the shaft was not so loose. Otherwise, i really like the product a lot... enough to give it four stars... :o)

Love the design with no locking through pins to worry about. Only reason for three stars is I received the product with cosmetic damage from being dropped.

Works great. The locking pin feels like it could be a bit wider but otherwise I love it. I’m a novice at towing so the adjustability of the height has helped make sure the towing has been optimized at all times.

Works great. With all the adjustments we can get our trailers to haul level now. Quality looks really good and it has the 2 size trailer hitch balls which makes it way more convenient.

VERY HAPPY, BUT STARTED TO SEE SOME RUST ON THE HITCH BALL AND ONLY USED TWO TIMES. THE VERSABILITY OF THE PRODUCT IS GREAT. OTHER THAN THE SMALL AMOUNT OF RUST ON THE BALL ITSELF, IM VERY SATISFY AND WILL BUY FOR MY OTHER TRUCKS.

Click to Enlarge

Sooooo....you sent me a product that was somehow put together backwards and I cannot take them apart somehow the ballhitch is stuck on the male portion backwards and defies gravity and doesn’t need a pin to stay on(becaue thier is no where to put the pin in cause it’s backwards

Click to Enlarge

Have done about 5k with this hitch, just once with a 4500lb camper but mostly with a 3000lb cargo trailer. The former in a highly raised position and the latter in the absolute bottom position. The hitch has worn very well and shows no signs of excess wear, save for the surface of the 2" ball, but it's not concerning. On a Jeep Grand Cherokee with a stock suspension, this seems to give the right balance of range of adjustment without dropping so low in the lower configuration as to scrape through dips, though it can still be done on very sharp dips with the hitch on the lowest setting. Overall, very pleased with it and love that it's lighter than steel and won't rust.