Most Popular Economy - Slide-Bar Jaw for Chevrolet Silverado

After ordering rails for a fifth wheel that I had in an older truck, I was told the rails I ordered would work with my fifth wheel, however after installing the front rail, the fifth wheel would not work with the rails ordered. I ended up ordering a new fifth wheel plate. That was easier than removing the frame brackets I had already installed. It appears that there was a mis communication between the person I talked to with etrailer. Instead of a 1/2 day install it took a day and a half plus wait time for the fifth wheel to get to my address. However once installed it appears to be good.

Click to Enlarge

The hitch worked great. Reason for the 2 stars is the package got delayed twice in transit and I had to reschedule the pickup of my fifth wheel. When I also received the package the main crossmember bar was bent at the mounting point. Luckily I was able to bend it back but UPS needs to get there act together.

Click to Enlarge

Etrailer sent me a one year follow-up email. Since purchasing this I've used it to tow our 11k lb camper about 5k miles. The hitch and slider have worked exactly as they should and I have no complaints.

Click to Enlarge

Well, I haven't towed with it yet but we'll see how that goes. I purchased this hitch because I needed to drop the height as much as 6 inches. My previous hitch was dropped to the lowest setting and still 17 inches high! This E16 goes down to 14 inches... Assembly was straight forward and all pieces were present ( even 4 big washers which were not illustrated anywhere in the instructions as to where they went) The hitch seems well built but the welder needs to be more thorough in cleaning his Slag (got my finger good when I picked up the top plate) Stickers were falling off everywhere (my heat gun fixed those) But a couple notable design flaws... The top cradle for the 5th wheel plate is a triangular shaped arch and the top plate has an axle which is perfectly round. So when the 5th wheel assembly is down in the cradle, there are only two little points of contact instead of the cradle fitting uniformly around the axle rods...we'll see what kind of wear this causes. Next, the green ring on the indicator rod looked like a 3 year old toddler wiped lipstick on it. (Green paint is supposed to be in the little groove cut in the rod but instead, is smeared all over the end of the rod) Lastly... The side plates have a two rows of holes for height adjustment...I have installed the bolts to position the overall height at the lowest possible setting. However, there are two more holes in the tie plate but the casting prevents the sideplates from dropping down even lower. Definitely confused as to what the extra holes are for and disappointed that I can't drop this even lower... Definitely seems heavy duty, but again, I haven't towed yet, so hopefully the play in the base rails doesn't translate into obnoxious clanking and rattling.... If so, I will definitely be doing another review

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge