Best 2007 Toyota Prius Trailer Hitch Locks

I don't know what to think about this product. Will it prevent a theft? Maybe slow down someone. Anyway, I installed it. Let's see over the coming months and years. I don't regret buying it, just don't have the experience to rate it any more than satisfactory.

Excellent product!! I generally don't like to have to assemble things once I receive a shipment, but this was truly so easy to assemble. I purchased the locking anti-rattle bolt, bike rack and hitch (hitch was installed by UHaul for $45.00) for a 2015 Toyota Prius with the package 5. Just took it out this weekend with 2 bikes on the rack and could not tell it was back there!!

The trailer fits and holds two bikes on my Prius. Only catch , it needs a mechanic to install because it is too difficult to reach under the vehicle.

I bought this rack for my 2010 Prius. The bike rack is easy to assemble and very sturdy. What proved challenging for me was getting the 1-1/4" shank to slip into the hitch I had installed by U Haul. After some pounding, it finally went into place. How I'm going to remove the rack from the hitch is probably going to be a challenge. The bikes are held very securely and I hardly noticed them as I drove. etrailer was great. They promptly answered question I sent by email, and the rack arrived within a few days of submitting the order.

Protect your investment!! I bought this to go with my thule roadway 2 bike rack, its a solid lock that prevents any movement from the rack

A local garage installed it for me at a reasonable cost, and it all worked without a "hitch!" Great pick for my 2016 Prius.

This seems like a very nice product and will work well. Lock fits as advertised and is simple to use. I would purchase one again if needed.

I needed a lock for my Pro Series 4 bike trailer as it only has a cotter pin and I was taking it off my van every time I went to the trail for fear it would get stolen. Giving it four stars since I haven't given it a test use but it fits perfectly! I could not be more grateful to a previous reviewer for suggesting this solution.

Click to Enlarge

Click to Enlarge

Clearance around the Tesla Model Y hitch receiver is tight but this anti-rattle hitch lock fit perfectly, even after torquing it to spec. The lock mechanism on the left comes very close to the 7-pin connector but it doesn’t touch and the lock rotates freely around the pin. Product appears to be of high quality.

Click to Enlarge

I have ordered and used this device before. What is disgraceful is the respect shown toward products shipped from etrailer. While the two devices/parts I ordered probably could have through a war zone without any damage, the fact is IF they are beaten out of the box while in shipping is not right. Add some appropriate packing. Grade F on your packaging.

Click to Enlarge

Click to Enlarge

Products arrived on-time and in great condition. Looking forward to a clean install.

It's a Master Lock, what can I say. Works great, fits great.

We purchased this rack for our Plug-in Prius because we wanted an easier way to get bikes on the car. It has worked like a charm. Very well designed and solidly fabricated. Also easy to install and uninstall. We have had fun moments waiting in line for ferries, with two bikes on the Hollywood in back, and two kayaks on top. It is something of a show stopper. Though Toyota does not recommend installing hitches, it is not clear what the problem is because it has worked well.

awesome lock set! The keyed alike hitch pin and cable with 4 keys are a great design idea. Also, the lock for the hitch pin can just be snapped onto the pin and secured without having the key inserted. I also have a Rocky Mounts Rack and that requires the key to be inserted and in the unlocked position to secure it on the hitch pin. Hollywood does it better!

As described.

Love working with trailer, especially Lori! The right part and it works as advertised. Easy to use, compact size.

Thanks for keeping me posted on my order, Korren. It arrived when promised.

The hitch lock spans my new 2.5 inch receiver with about 1/4 inch to spare and is now lockable. The original hitch tite pin is the same length but the lock on this item locks from the side and makes better use of the pin.

Click to Enlarge

It installed easily and quickly. Good price and fast delivery. This is the 3rd product from etrailer and Curt for me.

Had it on my hitch for a month this spring and then could not get the lock to work and the key was stuck in. Tried oiling and the key finally broke off in my hand. After another couple of months I snapped off the bent end of the pin with a long pry bar. The pin was rusting! Very disappointing for a Master Lock product. Just got a $xx locking pin through you that looks tougher but it is very hard to use: have to push in on the key pretty hard, while keeping the round lock from turning, and holding in the pin against the pushing on the key. I added a small stainless hose clamp to the lock so that the lock can be held to stop the spinning and hold the thrust of the key. We trailered our old Ferrari to Florida this spring with the old pin to win our class at Amilia Island – 1946 to 1950 limited production European sports and GT cars. If you check we have a lot of trailer stuff that we got from you in the past and your service and stuff have been great.

Was searching for a.lock for the hitch bolt for my Prorack bike rack and found a very helpful post on etrailer.com. I did check around and found the prices were excellent, the lock fit perfectly and the shipping speed and packing were great.

This is a junk system for an rv. Have to keep redoing codes every trip Don’t waste your money

Easy 30 Minute install. Would have been a 20 minute Job, but muffler heat shield needed a slight bend. took a few minutes to notice it.

Very inexpensive, strong hitch lock! Will knock the competitors out of the park. I would highly recommend this for a strong pin to hold your hitch in. I have one locking in my hitch and another locking in my ball.

Click to Enlarge

You need this!!

Click to Enlarge

This lock does not work with the Swagman XCT2 tilt rack. The diameter of the pin to too big to fit through the whole. Plus, the wholes in the rack where the pin is inserted has no treads so this lock and cable are useless. It appears I wasted $ on this purchase.

Master locks are a name brand. It is so nice to have all locks keyed the same. This decreases the chance the camper will get stolen.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Click to Enlarge

Ample room for the bits in the bag, which is nice. I used some of the shipping bubble wrap to pad it. Everything looks nice, works properly, and I've already installed the two trailer locks on my trailer. Decent theft deterrent, will at least slow 'em down or walk if they're lazy.

Very sturdy lock that fits my bike rack. I didn’t hook the bike rack up to the trailer hitch but the photo shows that it fits. There is other locks on the market but I highly recommend this lock!

Click to Enlarge

I'm happy with the product but have one observation. The length of the hitch pin is about 3/16 inch too short to use with the included washers. I can only get it to lock correctly with no washers. Thanks

Package was opened upon arrival.

Click to Enlarge

Click to Enlarge

The lock is high quality and I like the fact that it is stainless steel. Works fine with the bike rack (1.5 inch receiver pin easily goes through the rack on a 2 inch receiver). Saves a lot of time over having to bolt things together every time I want to take the bike's out.

Click to Enlarge

The hitch pin broke on the first trip with the SR2415 bike rack carrying 3 bikes. This rack is rated to carry 4 bikes and the hitch pin is compatible with this bike rack. As you can see in the photos, the color of the outer shell is different from the inner metal of the nut, which I perceive as the nut is not made of the same metal all throughout. Not sure why. The cable lock is NOT compatible with this rack and eTrailer should correct the answer registered on this site regarding this, which I had asked before purchasing this. Etrailer shipping was as always fast but unfortunately this product is seriously bad and is risky to use. Luckily my bike rack did not fall off the hitch and did not go flying on to other cars. I had to go to a local hardware store and buy a 3.5 inch length 1/2 nut and bolt, which worked just fine while returning.

Click to Enlarge

Click to Enlarge

Quick shipping. Perfect part! Thank you

Click to Enlarge

A must have for the Swagman XTC-4 bike rack. Sure, I want to protect my bikes but I needed something that would protect my $200+ bike rack, too. You need a wrench to tighten the bolt, which does a good job of keeping the rack from rattling but is a pain because you always need to have a wrench around. But that's not the fault of the lock. The lock is pretty neat in that you can rotate the key hole so it's covered up to keep mud and weather out. I'd buy it again if needed and the price here at etrailer.com was good.

Click to Enlarge

The product did not come with instructions. The videos at the manufacturer's site gave no instructions on installation. A video from a competitor explained how to install it. It can only be installed from the right side, that is the passenger side. A left-handed person, such as me, will naturally insert it from the left side. I did that repeatedly and of course it failed. Yes, I realize the world is right handed but a simple sentence saying it must be inserted from the right and not the left wouldn't take that much effort by the company. The same complaint applies to the bicycle rack itself.

Works exactly as described. Secures my Go Rhino bumper step, and keeps it from rattling. Only problem is I wish the bolt head was 3/4". Most socket sets don't go beyond 3/4", so you'll need a 7/8" box wrench or Cresent wrench to install/remove it.

Arrived quickly. Easy to install with the excellent video and instructions. I installed on my 2012 Forester with the Curt hitch I had previously purchased from etrailer. The locking hitch pin completely stopped my hitch rattle.

Click to Enlarge

Click to Enlarge

Would’ve been a great little lock had it actually fit in the housing. Too short for mine. Turns out my housing is 3”, not 2”. My bad. Paid $25 for it, etrailer wants $17 for return shipping fee? Pretty lame. So buyer beware, measure your housing first!

Click to Enlarge

About 6 months after owning it, the lock is completely froze up. Can't cut the darn thing off without cutting my safety chain hook up off either