Best 1999 Toyota Tacoma Bike Racks

Received the rack yesterday and it took all of 10 minutes to install in my '18 Tacoma this morning. Instructions were pretty thorough and should work great for our bikes (road and mountain). Quality mounts & skewers is a plus. Nice to have the option for locator pins in the side rail, too.

Click to Enlarge

The Swagman 2 bike carrier is fantastic. We installed it in our 2008 Toyota Tacoma which has a bedliner and rails. Installation was very quick and easy. The Swagman fits snuggly and securely into the rails. Also, etrailer.com has plenty of great information regarding the product on their website and shipping was prompt and free!

Velo Gripper Bike Rack install was super easy. Velo Gripper installed exactly as advertised. The videos were very informative and install was exactly as described. Install on 2023 Tacoma and it fit perfectly. Bike looks extremely stable so I don’t anticipate any issues.

Click to Enlarge

Click to Enlarge

Click to Enlarge

Holds my bike onto the C-channel of my Tacoma w/o issue. Will likely add some padding under the l-brackets to prevent rattling at highway speed.

This product was a little tricky to figure out at first, I have a 2018 Tacoma and I had to let the tailgate half way down to get the straps through. After I figured that out, it was easy to use and protected my tailgate. Great product! We've loaded three bikes on it at one time (26.5", 27", 29") and it worked great.

Just installed and fits well. Have not used it but tried putting bike on and fit well

The good: I like the way the bikes are held in and the ability to add the upright adapters to the bike frame holders. The straps are quality too. For a jeep with a spare tire, this is the perfect length to clear it. This rack is 5 stars from the bike holders to the base of it. The bad: the 2"receiver adapter and bolt are insufficient. I wish they made this in a solid 2" hitch. The entire setup is held into the receiver by a very short bolt. It only goes about half way into the receiver tube. So your hitch is only "secured" on one side. A hitch pin or bolt should go through the receiver tube completely imo so it can be secured on the other end with a retaining clip or nut. Because this only goes in the one side, the entire weight of the rack plus bikes are held tight to one side of the receiver by the undersized bolt and washer. A few bumps down the road and that bolt loosens. Now instead of distibuting the weight of the rack and bikes on the receiver and post, it's completely up to the bolt to keep you from losing the rack. The bolt threads get damaged too. I took this down a dirt road and nearly lost everything. I had to buy my own bolt with hd fender washers and lock washers to correct this. Thule should've provided this from the start. The current short bolt design where only one side of the receiver secures the rack is unacceptable. This rack is 1 star at best for the connection to the receiver.

Click to Enlarge

Hitch pin broke before I got it. Looks like a poor design for the locking pin, they might want to consider a different design. I got a 3/8 shear pin from Home Depot to replace and it works great. Bike rack is great!

Click to Enlarge

Looks like a good bike rack. I had to get a front receiver hitch and this bike rack so we could take our bikes when we tow our a-frame trailer. The bikes don’t block our view of the road much if the seats are removed.

Click to Enlarge

Click to Enlarge

We got the XTC2 to replace an old school rack. It was easy to put together and feels sturdy and well made. We will be using it on a 2016 Civic, 1999 4x4 Tacoma and a Casita Trailer. Looking forward to using it when the weather warms up.

Click to Enlarge

Click to Enlarge

Quite pleased with nearly everything regarding this rack. Setup was super easy right out of the box, loved that I didn't need any tools. Bikes feel very secure and I haven't noticed any shifting or movement while driving around. My only complaint is that it's possible for someone to remove (or steal) the locking skewers when there's no bike attached just by unscrewing the endcap. Even if the handle is locked in place, just unscrew the endcap and you can remove the whole locking mechanism. So...works fantastic when there's a bike to be hauled, but makes me uncomfortable when I just park the truck and walk away. Works great, could just be a bit more secure.

Garbage. You have been warned.

I looked at so many products, but then saw these pull up on a truck beside me one day. I started with two and mounted them to the rails in my Tacoma truck bed. After continuous use hauling our bikes to and from triathlons, I bought a third! I can now fit three road bikes across the bed of my truck and still have rooms for gear below them. Thanks of the great product guys.

Click to Enlarge

Click to Enlarge

Bike rack in Tacoma

Click to Enlarge

Click to Enlarge

Click to Enlarge

Works great! It would be nice is it came with the mounting hardware, however. eTrailer.com shipped the product immediately.

Have used the block head bike mounts by Yakima on trips of 800 to 1500 miles with no incident. Easy to mount the bikes and they have not released even on bumpy roads. Great product for my truck box and bikes are always in view. Easiest way I have found to transport our bikes

An extremely secured way of transporting my Cannondale mountain bikes. Well designed and very sturdy. Conveniently folds out of the way when not used and does not obstruct access to the truck bed and campershell on my Toyota Tacoma.

This thing is built like a tank! It is of the best fit and funtion I have seen in a bike rack! Solid as can be, fits my bikes perfectly and looks awesome! Plus it folds completely out of the way to access the rear liftgate on my 2022 Rav4!

Click to Enlarge

Click to Enlarge

Great service from etrailer and the rack arrived as expected. Fairly easy assembly. OK video on Kuat’s site, but didn’t cover the foot pedal. Really glad we got the 2” hitch. It tightened up and we’re impressed with the quality and the stability of the rack. We haven’t done a road test yet, but look forward to putting it to the test. We have a Ford F-150 and it works great. The bikes were fairly easy to load with the batteries out and two people. We do need the strap extenders for our RadMini Step Thru’s. The tires are too big for the ones that come with. Only one set of extenders came with the bike and one adapter for a smaller tire. It’s okay, but since it’s a two bike unit, would have been nice to have both extenders. Otherwise, we are really liking the look and stability.

Click to Enlarge

Kuat Beta is ideal 2" hitch, 2 bike rack. It is well made, relatively light, very sturdy, and installs in a minute. We recently drove for 2000 miles with our bikes on it. Very stable, no vibration. Minimal vibration only on very rough roads, as you would expect.

Click to Enlarge

Click to Enlarge

Built extremely well , simple to use and reasonable cost compared to other brands. Very satisfied. Ed T

Another great product from etrailer.

I was excited to recieve the Insta-Gater, however, when I tried it in my truck bed of my toyota tacoma it didn't fit with my bike frame, the bed of my truck was too small. Other than that I think the rack would have been fine. The only real compliant is I ordered two insta-gater truck bed racks and one box came wrapped nice but the other was completely damaged.

We just installed the bike rack this weekend for a trip down I95S. The assembly was easy, but I recommend you finish the assembly on the vehicle to make sure the crossbars correctly align with the rack. Someone also recommended you install the upright bar to make sure it faces to the outside of the car. This means you will have to switch the orientation for a passenger-side installation. It is a little more difficult to tighten the upright bar if it is located to the center of the car. Finally, though the clamps may seem narrow, you can fully remove the tightener knob to full pull apart the upright bars. We needed to do this to get my husband's bike to fit within the clamps. The installation was simple. It did require two people to put the bikes on top of a Tacoma Pick-up due to the height of the rack. The bikes were stable on the racks, and we noticed no issues while going down the road. Excellent product for the price.

Planning on bringing bikes while camping. I mounted 2 of the Swagman bike racks to my new Sportrack on my pop-up camper. The bikes fit perfectly. The racks seem sturdy enough. Not heavy duty, but for my needs they should be fine. Assembly was relatively fast and easy.

Click to Enlarge

After one year still love this product! Use it in a 2019 Tacoma Short bed with a leer cover. My bike fits perfectly and is stabilized during travel - so easy to take in and out. Also use the wheel holder which works well. When not using the Sari track its so simple to take out of truck and store.

Excellent product and well made. Looks great

I just received the 2-bike Rhino Rack for use with a 2016 Tacoma, It was easy to assemble and all the accessories for assembly were enclosed. I purchased this rack because it looked like it was very solid and well built. I think this is a very good bike rack. Please note that the Tacoma tail gate will open when the rack is angled down.

I purchased this bike rack a year ago and I use it A LOT. I had to buy and install a stabilizer because without it, the unit would sway back and forth even without a bike on it (very noisy). This makes removal more cumbersome but since I keep the hitch on year round it doesn't matter to me. The tilting function is fabulous allowing easy use of my RAV4 hatchback. I can even tilt it down with a bike on it. I got the 2 bike hitch. Plenty of room for two bikes to fit without rubbing. Lastly, the hitch has a sizable through-hole on the bottom to thread a good sized cable so I can lock my bike up. Sturdy. I highly recommend.