Replaces the single zone controller for your 2-fan speed Furrion Chill AC setup (sold separately). Communicates with your thermostat to control the temperature inside your RV. Short-cycle protection ensures your RV reaches its temperature set-point.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi there. I'm Michael with etrailer.com. Today, we're going to take a quick look at this Furrion replacement, single zone controller. This is going to replace the single zone controller for your Furrion Chill AC setup with two fan speeds specifically the 14,500 BTU and 15,500 BTU units that you see on the screen there. Just like the original, this is going to have a built-in temperature sensor that will communicate with your thermostat to allow you to control the temperature inside your RV. This does have the short cycle protection that's going to help prevent the air conditioner from cycling off prematurely to ensure that your RV does reach it's temperature set point.
This also has the automatic restart that will restore the most recent settings after there's a power interruption. And the mounting is going to be very simple. Basically just pull back the hardware that originally came with your unit, pull out that original controller and then put this one in its place using that same hardware. They do not include any new hardware but you should be able to use that original. This is a direct replacement from Furrion so you can trust everything is going to be exactly as you need.
You're not going to have to worry about fit issues or compatibility problems or anything like that. But just to give you a little bit extra reassurance, this is right at 12 inches in total length and I'm gonna call it about 3 and 1/4 of an inch to that outer edge of that plug there on the bottom. So sure that will match up with yours that you already have. You can see what we do have wires that are labeled to make it much easier to get hooked up to our system. And just like the original, This is rated for 115 volts of alternating current and 12 volts of direct current.
So if you are needing to replace the single zone controller for your Furrion Chill AC set up, this is going to be exactly what you need. That's going to complete our look for today. Again, I'm Michael with etrailer.com. Thanks for watching..
Average Customer Rating: 5.0 out of 5 stars (6 Customer Reviews)
Replaces the single zone controller for your 2-fan speed Furrion Chill AC setup (sold separately). Communicates with your thermostat to control the temperature inside your RV. Short-cycle protection ensures your RV reaches its temperature set-point.Perfect replacement. Installed with no difficulty. A/c and fan working as well as thermostat. Thanks for e trailers quick service and on line how to video.
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.