Bulldog Winch On-Board Air Tank - 2.5 Gallon - (8) 1/4" NPT Ports, (2) 3/8" NPT Ports

Video Transcript for Review of Bulldog Winch Vehicle Suspension - Air Suspension Compressor Kit - BDW42005

Today we're going to take a look at the Bulldog Wench two-and-a-half gallon onboard air tank. Now, this onboard air tank will let you store and transport compressed air on your Jeep, truck, RV, or other vehicle, so it's perfect for use with tire inflation and air horns, air lockers, and other standard duty air tools. This does hold two-and-a-half gallons of compressed air. It does include many ports. On this end, it includes two larger three-eighths inch diameter female MPT ports and it also includes eight quarter-inch female MPT ports. There's one, two, three, four right in the middle here and then on the very end you'll see four more.Now this is a steel tank.

It has a nice black e-coating, which is corrosion resistant. It does include the mounting hardware to let you easily mount this tank to your vehicle. Again, the capacity is two-and-a-half gallons. Ports again, eight quarter-inch female ports and two three-eighths inch MPT female ports. Maximum PSI on this tank is 200 PSI.

A few measurements on this. Want to measure the overall length, and we're going to include all the way to the end of the ports to give you the widest point. So the overall length on this is going to be right at 20 1/4 inches long. The width on it.. Again, if we turn it, we're going to measure where the ports stick out.

So you'll be right at seven and one-eighths inches wide. And the overall height on this from the bottom to the top of the port right up here is going to be right at eight and three-eighths inches tall.Now, the mounting brackets. There's two of them on the bottom here. Each one is going to measure five inches long, one and three-sixteenths inches wide, and that's the same on both of these. Now the holes center-to-center, the mounting holes, is going to be right at four inches.

If we measure overall length from this bracket to this bracket, it's going to be right at 13 and a half inches. The measurement on the holes center-to-center this way is going to be right at 12 and three-eighths inches. Now, we do offer different types of fittings that will fit the ports on here. They are listed on this product page as related products. They offer like a drain cox for the bottom here, safety valves, air line fittings, and many other fittings that are listed on this product page, and they are sold separately. But that should do it on the review of the Bulldog Wench two-and-a-half gallon onboard air tank.