Pop & Lock Cargo Safe Powered Deadbolt Lock - Left Side Rear Swing or Side Sliding Door

See what our Experts say about this Pop and Lock Vehicle Locks

• Can I Mount the Pop & Lock Cargo Safe Powered Deadbolt Lock item # 100383 Vertically?
  Yes, it can. The Pop & Lock Cargo Safe Powered Deadbolt Lock item # 100383 is designed to be mounted horizontally but it will function vertically.
  view full answer...
• Propane Hose to Connect Trailer's Propane System to Regulator
  Thank you for the photo and from that it looks like you have a 1/2 inch fitting, which is common for the hose coming from the propane system on your trailer. However, there are not extensions with a 1/2 inch fitting so we have replacement hoses of different lengths though you'll need to determine if they are the proper length for your needs. - MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 3 Feet # 100383-36-MBS - MB Sturgis Propane Hose Assembly - 1/2" Female...
  view full answer...
  
• Does the 1/2 Inch Female Flare Swivel x 3/8 Inch MPT Come in a 12 Inch Length?
  The MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 3' # 100383-36-MBS does not come in a 12 inch length. We only have the 3 foot already mentioned, 4 foot # 100383-48-MBS, and 5 foot # 100383-60-MBS. The only hoses in the 12 inch length are the pigtail hoses that connect the cylinder to the regulator.
  view full answer...
• Extension Hose for Dual Propane Tanks After Regulator on RV
  We have a large selection of propane extension hoses which I have attached for you. In order to find the correct one we would need to know what type of fittings you need on either end. If you do not know what type of fittings you need then you will want to take a look at the attached help article which explains all of the different types. The back check valve you are referring to is usually built into the leader hose that connects the tank to the regulator so you do not need an additional...
  view full answer...
• What Type of Fitting Matches my Propane Hose
  The fitting you have described matches the measurements I see on the 1/2" female flare like the one on the MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4' part # 100383-48-MBS or the 3' part # 100383-36-MBS. Check out the video my buddy Ellen did on the hose it is linked for you.
  view full answer...
• Is Teflon Tape Needed On Either End Of Sturgis Propane Hose # 100383-48-MBS
  When connecting hoses like the Sturgis Propane Hose # 100383-48-MBS, The 1/2 inch flare swivel fitting does not need any Teflon tape or sealant. Teflon tape or sealant can be used on pipe fittings like the 3/8 MPT on the opposite end
  view full answer...
• What Is The Actual Inner Diameter Of The MB Stugis Hose # 100383-48-MBS
  The inner diameter of the MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4 foot # 100383-48-MBS is 3/8 inch.
  view full answer...
• What Size Fitting Is Needed on RV Propane Hose That Goes from Regulator to Trailer
  The MB Sturgis Propane Adapter Hose - 3/8" Male NPT x 1/2" Female Flare Swivel uses a 3/8" fitting on the regulator side and 1/2" fitting on the manifold side. These are nominal fitting sizes so they don't actually measure 3/8" and 1/2", they are actually larger at .675" and .840" respectively.
  view full answer...
  
• Do I Need Sealant For My Gas Pipe, If So, What Is Your Recommendation
  No, you will not need to apply tape/sealant to the flare end of your MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4', part # 100383-48-MBS. I have included product description links and a video review link below.
  view full answer...
• Will the MB Sturgis Propane Hose Assembly # 100383-36-MBS Carry 200,000 BTU
  The MB Sturgis Propane Hose Assembly # 100383-36-MBS that you referenced has a psi rating of 350 but it doesn't have a BTU rating. I reached out to my contact at MB Sturgis and he said that this hose, which is designed to connect a regulator to an RV propane system, will easily carry 200K BTU under high pressure.
  view full answer...
• Shortest 1/2" Female Flare Swivel x 3/8" MPT Propane Hose
  There is not a 2 foot version; the shortest option is the 3 foot MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT # 100383-36-MBS.
  view full answer...
• Is There A Difference Between MPT And NPT Propane Fittings
  MPT is a male connection with NPT threads (national pipe threads). They basically just drop the "National" portion of the name on these parts and replace them with the male or female designation. The MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4' # 100383-48-MBS you were looking at has a male NPT fitting and would require a female NPT (FPT) fitting to connect to. You will want to make sure you don't mix up flare fittings with NPT fittings though as they do look...
  view full answer...
  
• Replacement For Marshall Gas Flexible Hose Model A6 Part Number 42611-48
  Yep, I sure can; the Marshall Gas Flexible Hose Model A6 part 42611-48 is a high pressure 48 inch hose with 1/2" female flare and 3/8" MPT fittings. You can replace the hose with one from MB Sturgis: - MB Sturgis Propane Hose Assembly - 1/2" Female Flare Swivel x 3/8" MPT - 4' # 100383-48-MBS
  view full answer...
• Is Propane Pressure Before Regulator High Pressure Propane
  The lines and ports that would mount before your propane regulator would be unregulated propane and not high pressure as high pressure propane is regulated just to a higher pressure. Low-pressure propane burners regulate gas intake to about 6 ounces per square inch, whereas high-pressure burners regulate gas intake to between 1 and 60 pounds per square inch. Pressure in a propane tank regardless of size can range between 100 and 200 psi typically.
  view full answer...
• Propane Adapter Hoses to Use as Extension for Regulator
  Yes, if you are talking about the inner of a propane regulator. The 3/8" male NPT fitting on the 3 hoses you asked about and are listed below, is the most common size for a regulator. But, there are some that use other sizes so you would want to verify that is what you have. - Propane Hose # 37207-31465 - MB Sturgis Propane Adapter Hose # 100383-36-MBS - MB Sturgis Propane Adapter Hose # 100383-60-MBS The other ends of these hoses are 1/2" female fittings, again you would want to verify...
  view full answer...
• Comparing High and Low Pressure Propane Hoses and Thermoplastic Versus Rubber
  Most RV propane systems use a low pressure regulator because the appliances are low pressure. You can check the information stamped into your regulator to determine if it is high or low pressure or offers both. High pressure regulators are usually 30 psi, such as # 108072. Hoses for high pressure systems are built to handle the higher pressure. Many hoses do not specify if they are high or low pressure and can generally be used for either system. The fittings on each type may have different...
  view full answer...
• Tee and Hose for Tapping Into RV Propane System Before Regulator
  For this application normally we recommend the MB Sturgis Sturgi-Flow T-Fitting w/ Hose for POL Valve # 103608 which comes with a hose for unregulated propane to run to throwaway style propane accessories. The hose length is 12 feet.
  view full answer...
• Propane Hoses Needed to Go From 100 lb. Propane Tank Through Regulator to Trailer Supply Lines
  You will need 2 separate hoses, one from the 100 lb. tank to the regulator and one from the regulator to the supply lines. The MB Sturgis Propane Pigtail Hose # 100019-36 (3 ft.) will go from the 100 lb. propane tank to the regulator using the Propane Adapter Fitting # 37207-30035. We do not have a hose that fits what you are needing from the regulator to the supply pipes. The typical set-up on a travel trailer is 3/8", I recommend that you verify you have 1/2". If you do, you will need...
  view full answer...
• How to Select Propane Hose with Correct Fittings for new RV Water Heater
  The best way to select a hose for connecting your new water heater to its propane source is to match up the types of fittings required. We have propane products - hoses, regulators, tees - with all sorts of fittings so we should have what you need. Please refer to the linked page. Water heaters such as the Atwood RV Water Heater # AT96110 use a 3/8-inch fitting like those on # 100383-36-MBS. This hose has a 3/8-inch male pipe thread (3/8 MPT) fitting on one end and a 1/2-inch female flare...
  view full answer...
• Installing Battery Isolator 08771 in 2002 Ford Excursion
  The way I read this is that you have a crank battery in your tow vehicle, you have or want to install, an auxiliary (Group 31 deep cycle lead acid) battery that will also be in the tow vehicle with use of the battery isolator to charge this battery. However, in addition you want to connect a second similar (Group 31 deep cycle lead acid) battery installed on a trailer, to this same charge circuit. Yes, the drawing that you have attached shows a circuit that will work for charging the...
  view full answer...
  
• Hose For Camco Horizontal 2-Stage Propane Regulator w/ P.O.L CAM59333
  The hose is going to depend on what you are using the Camco Horizontal 2-Stage Propane Regulator w/ P.O.L - 160,000 Btu/Hr # CAM59333 with. It has a POL fitting for the tank, and for the hose, one end will be 3/8" Male NPT to connect to the regulator, and the other end will depend on the fitting you need for your appliance. For example if you needed a 1/2 Inch - Female Flare fitting you could use the MB Sturgis Propane Adapter Hose - 3/8" Male NPT x 1/2" Female Flare Swivel - 4' # 100383-48-MBS. I...
  view full answer...
• Solution for Needing 4-1/2 ft Long Propane 1/2 inch Diameter Feed Hose
  We have a 4 foot section of 1/2 inch propane hose with part # 100383-48-MBS and we also have a 5 foot section with part # 37207-31475 but we do not have a 4-1/2 foot long section.
  view full answer...
• Propane Hose Replacement For 18CE Cavagna Group Recommendation
  Searching by part number it appears the MB Sturgis Propane Hose Assembly # 100383-48-MBS would be the replacemement part you need for at least the 18CE Cavagna Group replacement. The picture received on our end was a duplicate and you mention there's a different connector for it so if there is a different label for the second connector I would be happy to check that one as well. Regarding braided vs. rubber line durability, the braided stainless steel can protects the thermoplastic...
  view full answer...
  
• Replacement Propane Supply Hose From Regulator to RV Propane Supply Line
  It sounds like you're looking for a 3 foot long supply hose; typically the outlet end of a regulator will almost certainly be a 3/8" female NPT and from the picture you sent it looks like you've got a female flare connector on the other end that goes to the metal RV piping. Additionally, since you've said that the piping side is larger it sounds like you're looking for the # 37207-31445 which has a 1/2" Female flare connector on one end and a 3/8" male NPT on the other.
  view full answer...
  

Do you have a question about this Vehicle Lock?