Light up your truck bed with this waterproof LED light kit. Four 3" light blocks are wired together for 19' 2" of length and a total of 12 LEDs. Install the blocks along your truck bed with either 3M adhesive backing or screws.
Features:
Specs:
The EVO Formance truck-bed lighting kit is perfect for use under tonneau covers and bed caps or for illumination when you're loading and unloading your truck bed at night.
To attach the blocks to your truck bed, you can use the included 3M adhesive backing or mount with the provided screws for a more permanent installation. Included wiring attaches to a 12-volt power source. The 4 light blocks have 3 LEDs each, and there is 6-1/2 feet of flexible wire running from block to block.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at and showing you how to install the CIPA EVO Formance LED Truck Bed Lighting Kit, part number CM93326. 12 LEDs provide increased visibility at night, under your tonneau cover, or inside your camper shell. They're made with a waterproof housing, so they're safe to use outdoors. The kit comes with enough wire so you can place them as you see fit. The LEDs themselves are rated for 2,000 hours of use. Now that we've gone over some features, I'll go ahead and show you how we got it installed. We started off by positioning and mounting the LEDs with the included hardware.
We covered the wire with some 1/4 inch loom to clean up our install. It's available by the foot on our website with part number 7509-1. To help keep everything in place, we used some 1/4 inch loom clamps, and those are available on our website with part number A0250. This all runs back to our switch. We're using the Pull Lock Universal Rocker Switch, and that's with part number PK34308. Our lights and our 12 volt power supply connect to our switch using spade terminals, and you can pick those up with part number DW01899-1.
Our ground wire we ran to a factory ground down underneath. Our ground is attached to a ring terminal. We used part number 44-5310A. We're all set here. Let's go ahead and put our switch into the hole that we cut out for it. Give it a good push until it snaps in, perfect.
We got the 12 volt power from the truck's seven way, and we installed an inline fuse older with part number SWC9539. We put a 3 amp fuse in as required by the LED lights. With all that run you can see that our lights are working great. That's going to complete our look at the CIPA EVO Formance LED Truck Bed Lighting Kit, part number CM93326.
Average Customer Rating: 5.0 out of 5 stars (1 Customer Reviews)
Light up your truck bed with this waterproof LED light kit. Four 3" light blocks are wired together for 19' 2" of length and a total of 12 LEDs. Install the blocks along your truck bed with either 3M adhesive backing or screws.as expected, looks good, decent light.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.