Radial tire has a 16-ply rating and a 4,540-lb max load at 123 psi. Stud-piloted steel wheel has a 10 on 8-3/4 bolt pattern, a 6.1" offset, and a 3-step powder coat. Can be used as either the inner or outer wheel of a dual-wheel setup.
Features:
Specs:
Built-In Offset for Dual Applications
This tire-and-wheel assembly is designed to be used in dual-wheel setups. The 6.1" offset allows the wheel to be positioned closer to the trailer frame when used as the inner wheel of the setup. And if you use this assembly as the outer tire and wheel, the offset ensures that it will sit closer to the outside of your trailer.
This stud-piloted (Budd-type) wheel centers on the studs instead of the hub. This requires the use of inner and outer lug nuts (sold separately). The nuts should be threaded correctly for the left and right sides of your trailer.
Corrosion-Resistant Finish
The steel wheel goes through a 3-step finishing process that makes it both attractive and corrosion resistant. The wheel is first submerged in a zinc phosphate bath to ensure good paint adhesion. It is then e-coated with an acrylic primer base and finished on both sides with baked-on DuPont powder paint.
Provider radials are constructed with double polyester cords and double steel belts for increased durability and endurance. A protective layer of nylon is wrapped around the steel belts to help prevent tread separation. Provider radials are bake tested - a process usually reserved for automotive tires - to ensure that the rubber holds up over time.
Radial ply tires are designed for trailers that are towed on the highway. The cords on a radial tire are positioned at a 90-degree angle to the direction of travel so that they lay across the width of the tire from wheel lip to wheel lip. This construction prevents the cords from rubbing against one another when the tire flexes, unlike the cords on a bias ply tire. As a result, radial tires have less rolling resistance and heat buildup, which leads to a longer tread life and improved steering at higher speeds.
Determining the Bolt Pattern
The first number in the bolt pattern is the number of bolt holes. The second number denotes the diameter, in inches, of the circle on which the bolt holes sit.
To determine the bolt-circle diameter on wheels with an odd number of bolt holes, measure from the center of any bolt hole to the point halfway between the two bolt holes directly across from the first. (Example: "5 on 4-1/2" means 5 bolt holes with 4-1/2" measured to a point halfway between the opposite bolt holes.)
On wheels with an even number of bolt holes, measure from the center of one bolt hole to the center of the hole directly across from it. (Example: "8 on 6-1/2" means 8 bolt holes with 6-1/2" from the center of one hole to the center of another on the opposite side.)
Measuring the distance from the center of one bolt hole on the wheel to the center of a bolt hole right next to it can also help to determine the bolt pattern.
Do you have a question about this Trailer Tires and Wheel?
Condition: Surface Scratches
Notes: Item has cosmetic scratches and scuffs. Otherwise new and unused.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.