Blazer 12V LED RV Dome Light - Single - 6-1/2" Long x 4-1/4" Wide - White Housing

Blazer RV Interior Lights - 398SB

Use integrated switch or wire to a light switch to turn this single dome light on and off. Perfect for brightening up your RV kitchen when doing dishes or your enclosed trailer when loading gear. LEDs last longer and burn brighter than incandescents.

Features:

• Single dome light is perfect underneath an RV kitchen cabinet or inside an enclosed trailer
• Included energy-efficient, bright white LEDs last longer and burn brighter than incandescent bulbs
• Integrated toggle switch lets you turn the light on and off
  • Can also be wired to an interior light switch
• Clear plastic lens won't shatter if accidentally dropped like a glass lens would
  • Magnifying window in the lens increases the light output throughout your RV
• Durable, white polycarbonate plastic construction
• Easy, bolt-on installation onto the surface of your ceiling or wall - hardware not included
  • 2-Wire design - white for ground and black for power
• CSA

Specs:

• Overall dimensions: 6-1/2" long x 4-1/4" wide x 2" deep
• Wiring length: 6"
• Voltage: 12V DC
• Power draw at 12.8V: 0.15 amps
• Number of LEDs: 16
• 1-Year warranty

Need extra light over your camper kitchen sink for when you do the dishes? Or perhaps you need to upgrade the dim, old lights in your enclosed car hauler? This dome light has bright white LEDs that give you brighter light underneath a kitchen cabinet, in a walkway, above a shower stall, or inside a small hunting cabin.

LEDs are more energy efficient, last longer, and burn brighter than lights with incandescent bulbs. You won't have to worry about replacing bulbs that have brittle filaments. And because LEDs draw minimal power, the light won't drain your battery, overload your circuits, or produce too much heat.

Surface-Mount, Bolt-On Installation is Easy

This surface-mount dome light is incredibly easy to install as an upgrade or direct replacement of your existing light. To access the bolt holes, snap the lens off from the housing. Do not use any tools to remove the lens, as it will crack. Then, using hardware (not included), bolt the housing onto the ceiling, wall, or cabinet before re-installing the lens. The light has a 2-wire design that hooks up to ground (white wire) and power (black wire). Once you're finished, you can then turn the light on and off using the integrated toggle switch in the center of the light. And if you want to be able to control the brightness of the light, you can connect it to an LED-compatible dimmer switch (not included).

398SB Blazer 12 Volt LED RV Pancake Light - Surface Mount - 6 LEDs - White Housing