14-1/16" x 6-15/16" Rectangle. Triple LED trailer tail light serves 5 functions: brake, tail, turn, rear reflex, and incandescent backup. Durable white plastic base. Recessed mount in horziontal position. 8-Wire design.
Features:
Specs:
Recessed-mount trailer lights install with a grommet, which is often sold separately. These lights extend past the trailer surface and require a hole for installation. If replacing a light, you can utilize the pre-existing hole. If installing a new light, you will need to cut a hole or use a mounting bracket (sold separately) to complete the installation.
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today were going to be taking a look at part number 47-84-530, this is the Bargman triple taillight, 84 and 85 series. This is a three light fixture, its going to feature two red LED taillights right here and right here, and then one incandescent reverse light for your trailer or RV. The red LED lights function as a combination of break, tail and turn signals. LEDs are a great system to have in place, theyre going to last longer and burn brighter than incandescent lights. Theyre much more efficient so they have a lower power consumption and they have a quicker activation. The LEDs are going to respond much faster than incandescent bulbs.
On this side youre going to have the incandescent reverse light, thats going to be surrounded by Class A red reflex reflective lens. The taillight is designed to be mounted horizontally or vertically, whatever works best for your application; and its going to have the nice stylish white base with the rounded corners, gives it a really nice finished clean, sleek look. It is pre-wired so you got all the wires here on the back of the housings of the LED lights, its going to tell you which wire goes to which function or which wire operates which function. It actually says that the black wire is your stop and turn light, green wire is for taillight and then white wire is your ground, so a pre-wired design, this is Department of Transportation compliant. If you take a look at the overall dimensions starting with the overall length, thats going to give us a measurement of about fourteen and one-sixteenth of an inch long. If we measure the width thats going to give us a measurement of about six and fifteenth-sixteenth of an inch.
Now this is designed to be a recess mount installation, your nine hardware is not included but you got nine holes going around the entire housing, so one on each side and then three on top, three on the bottom we're on the sides however you would situation this, but youre going to have eight mounting holes in total; three here, three here, and then one on each side there. Again your mounting hardware is not supplied so you will need to supply that separately. Recess mount installation means that we are going to have a cutout in order for this to fit, so the cutout dimensions measuring from this point here to this point here its going to measure about twelve and eleven-sixteenths of an inch. Then go in this direction its going to need to have a cutout of five and a half inches. Were going to go and hook it up to our external power source, that way you can see what it looks with power running to it. Well also be able to turn off our overhead lights that way you can see in a low light setting.
Im just going to go and make our connections here. Now the first ones that youre going to see are going to be the taillights and then well rewire it to do the reverse light. This is going to be the taillight or running light function or feature, you can see here that they send out a nice consistent signal. Each light is going to feature a multi-diode design so it has multiple diodes within the light itself, thats really going to help optimize our light output. When we apply our brakes you can see how that illuminates for a stronger signal output, and its going to do that same thing when we activate our turn signals. Then if I hook up the reverse light you can see there thats a bright signal as well, now this is an incandescent bulb but it has the clear lens right here in the center, allows a lot of light to come through, really bright light, and then again youre going to have the Class A red reflex material built into the lens that surrounds that reverse light.
Thats going to do it for todays look at part number 47-84-530.
Average Customer Rating: 4.8 out of 5 stars (244 Customer Reviews)
14-1/16" x 6-15/16" Rectangle. Triple LED trailer tail light serves 5 functions: brake, tail, turn, rear reflex, and incandescent backup. Durable white plastic base. Recessed mount in horziontal position. 8-Wire design.These tail lights are a direct-fit replacement for the original lights on my 1990 Winnebago Warrior. I originally attempted to order the version with an amber center light (similar to originals) but that model is discontinued since modern vehicles no longer have amber lights on the back. It took me a couple of minutes to figure out what to do with the extra wires (the old fixture had a single hot wire and a common ground where each of the two LED lamps in the new fixture have two hot wires and a separate ground) but the wire key (molded into the back of the LEDs) proved helpful and I worked it out just fine. 242066
These were a replacement for the original incandescent style on my motor home. The new LED lights are 2-3 times brighter. This is a real safety plus especially when braking and night driving. 746189
Great product, fit perfectly into my application. Ordered, shipped and received in a timely manner without any hassles. Will order from them again. 714634
Great fast shipping. they were in good condition when I received them. I have not installed them yet on the RV. 637520
Installed these lights on our motorhome. They're loads brighter and more visible than the original ones, and were easy enough to put on. Well pleased overall with the product, delivery, and price. Thanks!!! 610049
more lumas less amp draw 599636
Delivery was faster than expected, the quality of the products are better than i thought they would be. Haven't installed yet but should be a snap. Thank you guys! 558739
I purchased new lights last year for my 92 sunline trailer. They are still working great and very bright. I'm very pleased with my purchase. 502560
Got it ! Looks great .. 454186
Got it ! Looks great .. 454185
Got it ! Looks great .. 454184
The lights work great. However, it would have been nice if there was a direction booklet with them to tell you the features of these lights. For example: When you turn on the left or right signal, the opposite tail light has a feature of a low blinking as well. I thought my grounds were bad, so I cleaned them up. Still had the low blinking from the opposite light. So I pulled them back out for the third time to check my connections. No difference. Then I came to the conclusion that this is a safety feature so drivers behind not only see the bright signal light flashing, but also a low flashing on the other tail light . This info would have been nice to know ahead of time before spending 4 hours to connect two tail lights. SEND FEATURE BOOKLETS WITH YOUR LIGHTS , PLEASE. 423504
Easy to install and a direct fit! 384767
I bought this light set for a spare to replace any light that may go bad 290732
I was already familiar with this brand of tail light, so I knew the product was of great quality. I decided to go LED this time, and boy, they are bright! Also, the package arrived a day earlier than what was estimated. Excellent service. Product arrived in perfect condition and well packaged. Will buy from you again! 115871
Good price, prompt shipping of a quality product 81128
Review from a similar 84/85 Series in Trailer Lights
Great product, it came a couple of days ago. It was packaged perfectly, no damage, but the box looked like it had been used in a Samsonite Commercial on television! 394932
PatrickA51 - 06/16/2018Review from a similar 84/85 Series in Trailer Lights
Great looking lights, can’t wait to install them. Was nice to find a product close in size to my existing lights, they’re slightly smaller but big enough to cover the existing holes. I’ve changed out all the clearance and side marker lights to LED’s, these will complete this project on my RV. Thank you so much, Bill Nikon 726370
Review from a similar 84/85 Series in Trailer Lights
I got them put on my 2014 forest River and it a wow how much better it light up at night !!! LOVE THEM !!! Paul 273880
Review from a similar 84/85 Series in Trailer Lights
Works very good very happy with it. 458244
Review from a similar 84/85 Series in Trailer Lights
Great Product. Easy replacement for older RVs to upgrade to LED. You will need load resisters to prevent hyperflash turn signals. No biggie. Very bright and really quick shippers here. 129802
The load resistors that we currently have are the Aluminum version 2 pack # P230004A-2
Putco LED Light Bulb Load-Resistors - Aluminum - Qty 2
$51.97 and the Ceramic 2 pack version # P230004C-2
Putco LED Light Bulb Load-Resistors - Ceramic - Qty 2
$34.00 both of which have a provide a resistance of 6 ohms.
Rachael H - 10/29/2014Review from a similar 84/85 Series in Trailer Lights
This is one of the best upgrades I've made. They are much brighter and come on much faster than the former incandescent bulb fixtures. 246501
Review from a similar 84/85 Series in Trailer Lights
The backup light on my RV went out. The problem was a rusted bulb socket. I would have to replace the whole tail/backup/brake assembly. SO......I decided to "go LED" and order the Bargman Triple Tail Light 84 series from etrailer. The order was processed and delivered quickly. There was a bit of work to modify the existing cutout to accept the new Bargman Triple Tail Light. But I think it was worth it. I also installed the LED Backup Light Upgrade Kit to the Triple Tail Light. These really look good on the MotorHome and I should not have to work on them again. The picture shows the old and the new installed for comparison. 479787
Review from a similar 84/85 Series in Trailer Lights
Bought two rear lights for my camper .Came in on thursday and installed in 40 minutes .This is my second order and , great service and prompt shipment . thank you.TOO YOU ALL AT ETRAILER ..... 405829
Review from a similar 84/85 Series in Trailer Lights
lights are to replace my old lights in my horse trailer, because I had to mount them vertical, the problem is the way that the frame is may ,will not allow water to drain out , the backup light is not seal from the back so this lets to collect dust/water inside of the light lens my fenders are where the lights are mounted and only has a plate to defect rocks and mud from the lights, I did have to widening the frame where my old lights mounting , notice that there is not much room for the bolts holes has to be kept close 577881
Do you have a question about this Trailer Light?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.