Bargman Tail Light w/ License Bracket - 5 Function - Incandescent - White Base - Red/Clear Lens

Ask the Experts about this Bargman Trailer Lights

• Replacement Bargman Tail Light with License Plate Mount Bracket
  Replacement tail lights with the license plate bracket are not determined by the SAE or DOT number. The fact you have Bargman lights with the license plate mount helps to narrow it down quite a bit. We have the following options: Bargman Tail Light w/ License Bracket - 5 Function - Incandescent - White Base - Red/Clear Lens # 30-92-003 Bargman Tail Light w/ License Bracket - 6 Function - Incandescent - Black Base - Red/Clear Lens # 30-92-108 Bargman Trailer Tail Light w/ License...
  view full answer...
• Replacement Taillight for Jayco Jay Series 1007
  I looked up pictures of your 2007 Jayco Jay Series 1007 and it looks like it has the same style of taillight as the part # 30-92-003. The great thing is that most trailer taillights are all basically the same designs across a few manufacturers so if you can match the appearance of what you have to a light you see on our site it's going to be the correct match. This is the version that comes with a license plate mounting bracket. If that's not needed you'd instead want the part # 30-92-001.
  view full answer...
• Replacement Trailer Lights for 1991 Jayco Pop Up Trailer
  Based on the dimensions you listed and how popular the Bargman trailer taillights # 30-92-003 I'd say this is most likely what you need. But if this doesn't look right email me a picture of what you have and I can see if we have a replacement. For a version of this that does not have the license plate bracket we also have the part # 30-92-002.
  view full answer...
• Replacement Tail Lights for 2013 Keystone Passport Ultra Lite Grand Touring 2300BH
  I was able to look up some photos of a 2013 Keystone Passport Ultra Lite Grand Touring 2300BH and it looks like you can use the Bargman Trailer Tail Light part # 30-92-003 for the driver side and part # 30-92-001 for the passenger side.
  view full answer...
• Replacement Lens for Bargman 92 Series Tail Light
  The Bargman Tail Light with License Bracket # 30-92-003 is actually the driver's side (which means it has a light to illuminate the license plate) and is the complete light assembly. However, since you mentioned cover I believe you are looking for the replacement lens and the replacement lens for this light is the Replacement Lens # 30-92-708 For the passenger side, which is the Bargman Trailer Tail Light # 30-92-001, the correct replacement lens is the Replacement Lens # 30-92-012.
  view full answer...
• Difference Between Bargman 92 Series Trailer Taillights # 30-92-003 and # 30-92-001
  The difference is that the # 30-92-003 has a license plate bracket underneath it plus a light to illuminate the plate and the # 30-92-001 does not.
  view full answer...
• Availability of a Replacement License Plate Mounting Bracket for Trailer Tail Light # 30-92-003
  Since the license plate mounting tabs are part of the entire housing on light # 30-92-003, you will have to replace the entire light. The good news is this particular light is relatively inexpensive.
  view full answer...
• Replacement Trailer Lights to Replace Reflect-O-Lite 910-950
  From my research the Reflect-O-Light 910-950 is an 8-1/2 by 4-1/2 inch light. For a replacement we have the Bargman # 30-92-003 for the left side and # 30-92-001 for the right. We do not carry that specific brand light so this is the best option we can offer.
  view full answer...
• Replacement Taillight Recommendation for 2003 Winnebago Vista
  For the driver's side (assuming you need the license plate bracket), use part # 30-92-003 and part # 30-92-001 for the passenger side. If your existing lamps have reverse lamps, use # 30-92-004 for the driver's side and # 30-92-002 for the passenger side. The Bargman 92/94 series taillights use 1157 bulbs so if you wanted to convert them to LED you would just need to go with a matching LED style bulb like the part # P241157R-360 which is a pair of 1157 LEDs. I was not able to find...
  view full answer...
• Bargman SAE-AILRST-94 Taillight Asembly Replacement for Trailer
  Thanks for the pictures! You don't need reverse lights based on them so the part numbers you'd want are driver's side (assuming you need the license plate bracket), use part # 30-92-003 and part # 30-92-001 for the passenger side.
  view full answer...
• Picking Out Replacement Taillight Bulbs for 1990 Jayco Popup Camper
  I looked up a few pictures of a 1990 Jayco popups and found that they all seemed to have taillights like the # 30-92-003 that you referenced. This light takes a 1157 bulb like the # A1157B for an incandescent bulb. The side clearance lights appear to be the part # MC31RB for red and # MC31AB which use 194 bulbs like the # A194B.
  view full answer...
• Installing Replacement Tail Lights on 2014 Jayco Flight Trailer
  The 003-81L tail light referenced in your question is extremely similar to the Bargman Trailer Light # 30-92-003 that we currently have available. There should be 3 wires coming out of the light assembly you are trying to install. The white wire is for ground, the green wire is for the tail light circuit and the black wire is for the brake/turn circuit. If you are unsure of the wire functions on your trailer, I recommend simply testing them with a circuit tester like # PTW2993 while...
  view full answer...
• Replacement Taillight Assemblies with SAE-AILRST-94 DOT Markings on Lenses
  It sounds like you're needing a Bargman 92/94 series taillight. The DOT number you provided usually doesn't steer us to a replacement lamp, the actual part number of your lamps should be printed or stamped on the lamp housings themselves, not the lens. However, this particular one has come up enough that we had record of it. For the driver's side (assuming you need the license plate bracket), use part # 30-92-003 and part # 30-92-001 for the passenger side. If your existing lamps have...
  view full answer...
• Availability of Replacement Bargman Trailer Taillights
  We carry a wide range of Bargman trailer lights and replacement parts too. The light you referenced is the Bargman Trailer Tail Light # 30-92 series. All complete trailer lights and light parts from Bargman are shown on the linked page. Just click on taillights to see only that type of light. There are several versions of this light style. Part # 30-92-003 measures 8-9/16 long x 4-9/16 wide x 2-1/8 thick and has mounting hole centers spaced at 7-inches apart on its two mounting tabs....
  view full answer...
• Replacement Tail Lights for a 2006 Forest River 5th Wheel Travel Trailer
  The light in your pictures seems to be a # 30-92-001, wider at the bottom, little tabs on the sides holding the lens on. If your existing light is approximately 8-1/2" long x 4-1/2" tall then it will fit. The version with the license plate bracket is # 30-92-003. I think you have found the lights you need! The RVST50 and RVST51 have been discontinued by Optronics and are nearly identical.
  view full answer...
• How to Wire the Left Rear Camper Tail Light # 30-92-003
  When wiring the # 30-92-003 Tail light with license plate light, you should only have one wire going to the turn/stop signal connection and one wire going to the taillight connection on each side of the trailer. The Left side turn/stop wire on the trailer is yellow, Right side turn/stop wire is green, taillight wire should be brown. On the left side you should connect the yellow wire from your trailer lighting to the green wire on the # 30-92-003 tail light, and connect the brown...
  view full answer...
• Replacement Lens for Bargman 30-91-010 and 30-91-011 Camper Tail Lights
  The Bargman light assembly numbers you referenced in your question refer to the Bargman Trailer Tail Light # 30-92-003 and # 30-92-001. These assemblies measure 8-9/16 inches long, 4-9/16 inches wide and 2-1/8 inches thick. You can verify these measurements on your existing unit. For just the replacement red lens, you will use part # 30-92-012. This will be a direct replacement for your existing assembly.
  view full answer...
• Replacement Trailer Taillight Recommendation for 1989 Jayco Jay Series 1006 Pop Up
  The best replacement we are going to have will be the part # 30-92-003 and the part # 30-92-001. I looked up your light assemblies and while we don't have an exact match these two are very close and both use three wires for installing.
  view full answer...
• Replacement Tail Light Assembly for 1988 Coleman Chesapeake Pop-Up
  Actually, we offer a closer replacement that includes a reverse lamp, more like what you have now. For the driver's side, use part # 30-92-004 or # 30-92-002 for the passenger side.
  view full answer...
• Replacement Tail Light Solution for 1998 Jayco Eagle
  found an answer to your question, unfortunately there are no direct replacement for your 1998 Jayco Eagle. The lenses have been discontinued and are no longer available. However, we do carry new taillight assemblies that can replace the OEM lights on your camper. Bargman Trailer Tail Light - Stop, Tail, Turn, and License Red Lens # 30-92-003 and the Bargman Surface Mount Tail Light - Red # 30-92-001 will fit on our camper. These light assemblies will function as tail, stop, turn signals....
  view full answer...
• Needing a Replacement Taillight Cover for a 1998 Jayco Eagle Popup Camper
  I found an answer to your question, unfortunately there are no direct replacement lenses for the Wesbar lights on your 1998 Jayco Eagle. The lenses have been discontinued and are no longer available. However, we do carry new taillight assemblies that can replace the OEM lights on your camper. Bargman Trailer Tail Light - Stop, Tail, Turn, and License Red Lens # 30-92-003 and the Bargman Surface Mount Tail Light - Red # 30-92-001 will fit on our camper. These light assemblies will function...
  view full answer...
• Difference Between Bargman 30-92-003 and Bargman 34-92-003 Tail Light Assemblies
  The lights themselves are identical. I reached out to my contact at Bargman who said that the only difference between the Bargman Tail Light Assbemly # 30-92-003 and one with the part number 34-92-003 is how it is shipped to the company. One of them is shipped in bulk while the other is bagged.
  view full answer...
• Recommended Replacement Tail Light/Plate Holder for 2015 Keystone 2510RB Travel Trailer
  I checked photos of your Keystone 2510RB travel trailer on the manufacturer's website and no detailed photos or specs are provided for the license plate holder. However, we are familiar with this light assembly (thank you for including that information) and you can use part # 30-92-003 as a replacement, or part # 30-92-004 if you also have backup lights.
  view full answer...
• How to Ground a Bargman Trailer Light to an Apache Tent Trailer with an Aluminum Frame
  The Bargman trailer light # 30-92-003 has a separate ground wire that you can use to ground the light. Since the trailer has an aluminum frame, you will want to ground the lights to the main ground at the trailer connector even if you have steel bolts. Aluminum does not provide the best electrical ground to complete a circuit.
  view full answer...
• Availability of Wedge Mounting Base for Bargman 92 Series Tail Light
  I believe the Bargman Wedge Base, part # 30-92-044 is what you are looking for.
  view full answer...
• Replacement Tail Lights for a Bargman 30-91-010 on a Fleetwood Prowler
  The 92 series Bargman lights are not quite the same as the 91 series (which is no longer available). Basically what you have is a double tail light similar to # 30-84-527. The way that these double tail lights are wired is the same as what you have now. All of the doubles are recessed mount though, not surface mount. This means that a hole would have to be cut in the back of the RV to install the new lights.
  view full answer...
• Need Replacement Tail Lights for a 1999 Jayco Eagle 12so
  It is possible that the Bargman Tail Light, # 30-92-003, will work on your 1999 Jayco Eagle 12, but that will depend on the type of tail lights it currently has. Some of them also used a wrap-around style lights. The best way to find replacement lights is by using the part number of the current lights. Wesbar stamps the part numbers on the base of the light assemblies, so we can start there. Look at the base of both lights and look for a part number. Keep in mind, the SAE number is...
  view full answer...
• How to Remove Bargman Tail Lamp Assembly 30-92-003 From Coleman Santa Fe Pop-Up
  To remove the lamp assembly, you would first remove the lens by gently prying at each side. Once the lens is removed, you should be able to easily access the 4 screws holding the lamp base to the camper. Take a look at the photo I edited for you.
  view full answer...
• Fitment and Compatibility of Tail Light with License Plate Light for Heartland North Trail 28BRS
  Even though we do not have the OEM information to confirm that these are the same lights you have on your Heartland North Trail 28BRS, I was able to find many images of your Heartland and they appear to be the same but may have the black base like # 30-92-108. If your current light is a two wire design then either of these will work great at a replacement. The dimensions of the lights are 8-9/16 inches long x 4-9/16 inches wide x 2-1/8 inches thick Alternatively, if you have a 3 wire...
  view full answer...